0
You will need a small gear puller to do this. They make one that is smaller than a conventional gear puller (for removing crankshaft pulley/dampers) because the clearance behind the damper is a little thin between the pulley and the block.
Try NAPA or AutoZone. AutoZone may have them in a blister pack on display.
What else can I help you with?
How can you tell if a crank sensor is bad on a 1994 Nissan Altima?
How can you tell if a crank sensor has gone bad on a 1994 Nissan altima
Location of crank shaft position sensor of a Nissan Altima 2.5 04?
Location of crank shaft position sensor of a Nissan altima 2.5 2004? send diagram please
How do you remove crank shaft pulley megane?
To remove a crank shaft pulley you need to first jack up the car. Next, remove the bold holding the crack shaft pulley in place and remove the unit. Reverse direction to put the new crank shaft pulley on your car.
Where is the crank sensor located on a 1993 Nissan Altima?
There is none; it's the distributor.
Where is the crank shaft sensor on a 1993 Nissan altima?
I don't believe that the altima had a crankshaft position sensor until 1995.
Does a 1993 Nissan Altima have a crank shaft sensor?
I don't believe that the altima had a crankshaft position sensor until 1995.
How to remove crank pulley?
On most newer cars, the crank pulley is one piece with the harmonic balancer.... Remove it with a harmonic balancer puller.
Where is the crank shaft sensor on a 1993 Nissan altima located?
I don't believe that the altima had a crankshaft position sensor until 1995.
Where is the PC value located on the 1998 Nissan altima?
It is located between the intake manifold and the crank.
Would ethanol gasoline damage crank sensors on 2003 Nissan Altima crank sensors?
Should not. The crank sensor does not come in contact with the fuel nor the exhaust.
How do you remove a crank pulley for a 1991 Acura Integra 18dohc?
To remove the crank pulley from a 1991 Acura Integra 1.8 DOHC, first, ensure the engine is off and cool. Disconnect the negative battery terminal, then remove the serpentine belt by loosening the tensioner. Use a crank pulley holder tool or a suitable method to prevent the pulley from rotating, then loosen and remove the central bolt using a socket wrench. Finally, carefully pull the crank pulley off the crankshaft.
How do you change the crankshaft position sensor on a 2003 Nissan Altima?
How do you change the crank sensor on a 2002Nissan Atima3.5?
