first pop that little light out on bottom corner of door than there is a bolt above the handle 10mm. the pop the plastic cover at the top of the door by the mirror but on the inside of the door off. after that pop the window control panel out with a screw driver than there one more screw and then slide the panel up pull straight up and putting it back on slide it down on the hooks .
Remove door panels.. Unscrew old speakers..Screw in new speakers..replace door panels...ready 2 GO..
Remove the rear door panel.
Removing the door panels on a 2000 Ford Ranger is easy. All you have to do is snap out the old panels by unscrewing the bolts and screwing in the new ones.
The 2000 Mercury Villager front door panels are held in place with two retaining bolts and eight retaining clips. Remove the retaining bolts and pry outward on each retaining clip.
door latch diagram for 2000 Chevrolet silverado
I dont know. Ive never done it!
pop the switch panel off and then the door mount support with a socket
The 2000 Buick Century door panel is held in place with for retaining bolts and 10 retaining clips. Remove the retaining bolts and pry outward on the retaining clips.
http://prodactor.blogspot.com/2005/09/removing-door-panel-from-toyota.html
I too was looking for an answer to this question. I found an answer on this forum under 2002 Chevy Tahoe. These panels should be similar if not the same. Hope this helps.
I just need to figure out how to take my door panels off my car, 2000 Mitsubishi Eclipse, so I can install some new speakers.
Check out this website*** http://www.a1electric.com/grandam.htm *** It shows how to remove the panels on a 2002 model. It might be similar.