The answer was on a forum web page for 1995 - 2001 Ford Explorers. It also helped me with the same problem. There is a plastic pinch clamp that must be squeezed, then wiggle and pull the hose off. Use your fingers because a tool may break the plastic. When you put it back on you will hear a sharp click when it is back in place. Full instructions can be found at www.explorerforum.com/Singleton/web/pages/fuelpump2.html
how do you replace rear wiper motor on a 1997 ford explorer
You can replace the rear main seal in a transfer case, on a 1997 Ford Explorer, by removing the transfer case cover. Remove the seal, using a seal puller. Reverse the process to install the new seal.
You can not. There is an anti siphon valve in the filler neck. You have to remove the filler neck from the tank and drain from there.You can not. There is an anti siphon valve in the filler neck. You have to remove the filler neck from the tank and drain from there.
I AM TRYING TO REPLACE A RACK AND PINION IN A 1997 FORD EXPLORER COULD YOU TELL ME OR GIVE ME A PICTURE ON HOW THE OLD ONE COMES OUT>
you don't you replace the whole hose. i hear it is better to remove the bed, than to remove the gas tank. You can drop the tank, but that is too hard, better lift the bed and do it the easy way. As soon as you begin to lift the bed you have to remove the three screws holding the filler neck to the bed, open the filler door you will see the three screws. Lift the bed and replace the filler neck. also if any other hose is bad you can do those at the same time.
Check the door jambs or fuel filler door - should be a label
The top review of Explorer mirror saleson Amazon has a clear detailed explanation of how to replace an Explorer left hand miror.
Remove the connector nearest the firewall. You will need a special plastic tool to slip around the flange in front of the accumulator and unlock the spring clamp. To replace, reverse the process.
i need to look at the book or the page
Need to replace computer on 1997 ford explore. Need to know location of computer?
How does one remove and replace the starter in the 1997 Bravada??
take the three or 4 Phillips screws out of the taillight, remove the light assembly and replace the bulb......all with the tailgate up of course.....
Remove the rear wheels, then the calipers and simply pull the rotors off. If the parking brakd is on the caliper you need a special tool ot retract the caliper.
Drain the water from your 1997 GMC Yukon cooling system. Remove the water supply hose. Remove the thermostat housing retaining bolts. Remove the old thermostat and replace with the new thermostat.
First of all, it's not a "bulb" but a florescent tube and ballast assembly. To remove and replace, you must first remove the plastic covering on the inside of the rear hatch. Then it's just a matter of removing the 0ld and putting in the new.
you must remove the fuel tank to replace the pump.
Remove the old mount & replace with the new.
open the gas filler cap One way is to remove gas cap
remove and replace water pump in 1997 Oldsmobile aurora
You need to remove the rear seat, then remove the package tray.
Remove the belt, then remove the bolt holding in the idler pulley.
remove the entire dash
yes you have to remove the tank and its best to change the pump also.