Add your answer:
Related Questions
Where is the inertia switch on a 1991 Isuzu trooper?
According to the wiring diagram, there is no inertia switch. There is only a relay switch in a 1991 Isuzu Trooper.
Where is the fuel pump located on a 1991 Isuzu trooper?
in the fuel tank
What engine can i replace my 1991 Isuzu bighorn with?
a trooper engine or a rodao engine
Firing order for a 1991 Isuzu trooper?
The firing order for a 1991 Isuzu Trooper 2.8 liter 6-cylinder is 1, 2, 3, 4, 5, 6. The spark plug gap is .045 (in thousandths of an inch).
Need firing order for Isuzu trooper 6vd1?
what is the firing order for isuzu bighorn 1991 3.2L (Lotus) Engine 6vD1 Doch
Radio wiring schematics for a 1991 Isuzu trooper?
You can find wiring schematic @www.modifiedlife.com falconspath
Where can you find an exploded view of the 2.6 liter engine in a 1991 Isuzu trooper?
Check my isuzuparts.com
What type of freon do you use for 1991 Isuzu Trooper?
Would have been built for R12, can be converted to R134a.
How do you remove the spare tire on 1991 Isuzu pick up pup?
how to remove spare tire 1990 Isuzu Pick Up
What is wrong with a 1991 Isuzu Trooper when attempted to start antifreeze comes out of the muffler and exhaust?
blown head gasket
Burning black smoke and running rich?
isuzu trooper e.f.i 1991 black smoke and running but no power
1991 Isuzu trooper over heating why?
my niece's was overheating I replaced the radiator cap and it hasn't happened since FYI
What would cause the tail light fuse to keep blowing on a 1991 Isuzu trooper?
Short in the wiring or one of the bulb receptacles.
What is the power button for on a 1991 Isuzu trooper for?
it just resets the shift points on the trans. it allows you to hold a gear a little longer.
What should the oil pressure be on a 1991 Isuzu Trooper 2.6?
on a1990 Isuzu pickup 2.6 same engine 7.1 psi at 900 rpm and after warm up 58.9 at 4000 rpm
Whwere is the radiator drain plug on a 1991 Isuzu trooper?
Should be on the bottom passenger side of the radiator, facing the engine...That's where mine is...
How do you replace a heater core in a 1991 vw jetta?
Remove the water from the cooling system. Remove the water lines from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
Where is the engine control module on a 1991 Isuzu Trooper?
The engine computer on 1991 Isuzu Troopers is mounted on top of the transmission hump, under the center console in the cab of the vehicle. If you have the 4L30E transmission then the transmission computer is mounted next to the driver side (Left) front speaker.
How do you replace heater core on 1991 caviler must you remove dash?
no
Replace a heater core on a 1991 Mazda 626?
# Disconnect the negative battery cable. # Drain the engine coolant. # Remove the instrument panel/dash assembly from the vehicle. # Remove the heater hose(s) and cap the hose(s). # Remove the attaching nuts and remove the heater unit assembly. # Remove the heater core attaching screw and remove the heater core..............
How do you replace a 1991 dodge Dakota heater core?
Drain the water from the cooling system. Remove the water hose from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
How do you replace the heater core on a 1991 C1500 Chevy pickup and does the Dash have to be completely removed?
You do not need to completely remove the dashboard in order to change the heater core. Remove the water hoses from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
What would cause your 1991 Isuzu trooper to lose power and then stall after it warms up then it won't start again until it cools down about 10 to 15 min?
ECM
When was Isuzu Panther created?
Isuzu Panther was created in 1991.
Where is the low side pressure hose for AC on 1991 Isuzu trooper?
Find your ac compressor. Follow the larger hose. Up to the metering device outlet, that's your low pressure side.
