Don't know, would like to know.
There is u- shaped flat peice of meltal and it's a window handle clip remover Auyo zone has thewm and they do now cost much! Good Luck!
The question you ask is too involved for a proper answer. You may want to go to a car parts store, or book store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
Sure wish there was an answer to this one.
That should be the window defroster.
Remove the door panel, then remove the plastic sheeting. Then you can gai access to the window tracking. Remove the two 10mm nuts, that hold the window glass to the upper track. Remove the glass from the door, and install the new one in the reverse procedure.
remove the door panel and the window crank (if manual windows) , if auto windows remove the piece behind the door handle and unclip it from the buttons unscrew all screws around the door panel with a regular screw driver once you have done all that u will see the speaker remove it with a star head screw driver
check the fuseor the plugin at the rear window or mabey a broken wire
look up under the back window through the trunk and you will see them right there.
you prolly need a new window motor... check a local junkyard.
Trust me there is a clip it is a real cheap wire horseshoe shaped clip, the only way to remove this clip is you need to purchase a tool just for removing clips on window cranks.
I'd suggest picking up a Haynes or Chilton manual for your car. I'm pretty sure it will show you what you need to know about the window, to say nothing of being invaluable if you do much of your own repair work. FriPilot
If your window is like my grand am the glue that holds the track and window together is not holding properly, so window keeps coming off track. I have not found a glue that holds yet.
You can get a Window handle remover from an automotive parts store that'll help remove a clip that holds on the handle. With this you can remove the clip and then the handle.
There is a "C" clip behind the handle that has to be removed. Your local auto parts store can sell you a simple tool to remove that clip for less than $10.
You can use a bolt and lock nut, probably 1/4 inch.
I can't tell you precisely, but you'll see it when you pull the inside door panel off to access it.
Me and two of my friends have had problems with one or another window not responding, every time it was the actual switch in the center counsel that went out
In order to replace the electric window motors on a Pontiac Grand Prix you will need to unscrew the Torx screws on the door, life it back to remove the plastic pieces. Remove all connectors, and the plastic covers.
the fuse for the rear defogger is in the fuse pannel located next to the drivers door. on a 2001 sunfire it will be a 30 amp fuse located on the bottom row third fuse towards the door
Manual window cranks are held on with a screw on 1997 Honda Civics. Remove the plastic cover on the handle to reveal the screw. Loosen and remove the handle. Replace with a new unit.
You will need to remove the inside door panel in your 1989 Ford Mustang. Remove the window retaining clips. The window will lift out. Reverse the process to install the new window.
It requires a special tool available at the parts store cheap. Use 2 Screwdrivers, force a rag between the door and the window crank handle to give you some space, then pry the clip apart or take a small hook, hook under the loop of the pin and pull up.
To remove the window knob,you need to purchase a tool at any auto parts store, you would then slide the tool behind the window crank and simply push out the clip that holds the window lever in place.
go to a junk yard and find a sunfire or a Chevy cavalier take the door panel off and unbolt the window mechanism and go home and take your door panel off and replace the mechanism