answersLogoWhite

0

1) Twist it coulterclockwise, then pull it out or

2) Repeatedly strike it with a large hammer until it pops off.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

How do you reset the gas cap light on 2005 buick rendezvous?

The gas cap light will go out automatically after you tighten, or replace the gas cap.


How do you remove the strap ring from 2003 Buick Regal Gas Cap?

On my 2002 Regal I just cut the strap.


How do you change coolant in rendezvous?

step1: remove coolant cap step2: put coolant in step3:put cap back on


How do you fix code p0449 on 2003 buick rendezvous?

Code P0449 on a 2003 Buick Rendezvous indicates an issue with the evaporative emission control system (EVAP), specifically related to the vent control valve. To fix it, first inspect the wiring and connectors for any damage or corrosion. If they appear fine, test or replace the vent control valve itself, which is located near the fuel tank. Additionally, check for any leaks in the EVAP system, including hoses and the gas cap, to ensure a proper seal.


How do drain coolant from radiator on a 2005 buick rendezvous?

To drain the coolant from a 2005 Buick Rendezvous radiator, first ensure the engine is cool and then locate the radiator drain petcock, usually found at the bottom of the radiator. Place a container underneath to catch the coolant, and open the petcock to allow the coolant to flow out. Make sure to also remove the radiator cap to facilitate drainage. Once drained, close the petcock and dispose of the coolant properly.


Is it safe to remove the radiator cap on a 1999 Buick Century when the engine is cool?

Yes.


Where do I add brake fluid on 2003 Buick Rendevous?

To add brake fluid to a 2003 Buick Rendezvous, open the hood and locate the brake fluid reservoir, which is typically found on the driver’s side near the back of the engine compartment. The reservoir is usually a translucent plastic container marked with a "Brake Fluid" label. Ensure the fluid level is between the "MIN" and "MAX" markings; if low, carefully remove the cap and add the appropriate type of brake fluid (usually DOT 3 or DOT 4). Be sure not to overfill and check for any leaks if the fluid is low.


How do you remove hubcaps on 1987 Buick Electra?

Use the lug wrench. If the car has wire wheel caps, you may have to use the adapter tool to remove the center cap and unscrew the cap from the hub.


Change the distributor cap in a buick rendezvous?

Does not have one. Just a coil pack, top of the engine, near the wiper transmission area. Follow the ignition wires. Should not need replacement at all.


Where is ignition coil 3 located on a 2003 dodge ram?

The ignition coil should be inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.


How do you open the Buick Lacrosse gas cap?

To open the gas cap on a Buick LaCrosse, first, ensure the vehicle is in the "On" or "Run" position. Locate the gas cap release button, typically found on the driver's side, near the door or on the dashboard. Press the button, and the gas cap door will pop open. Simply twist the gas cap counterclockwise to remove it.


How do you burp or bleed the cooling system 2002 Buick rendezvous?

To burp or bleed the cooling system of a 2002 Buick Rendezvous, start by ensuring the engine is cool and the radiator cap is removed. Fill the radiator with coolant and run the engine with the heater set to the maximum setting, allowing air to escape as the engine warms up. Keep an eye on the coolant level, adding more as necessary until all air bubbles are gone and the coolant stabilizes. Finally, replace the radiator cap securely once the system is free of air.