answersLogoWhite

0


Best Answer

Try the installdoctor.com. Worked for me.

User Avatar

Wiki User

โˆ™ 2007-03-04 15:40:36
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides

๐Ÿ““
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you remove the radio of a 1999 Chevy Astro?
Write your answer...
Submit
Related questions

How do you remove the dashboard fascia on a 1999 Chevy Astro?

How do you remove the dashboard fascia on a 1999 Chevy Astro?


How do you replace a starter in Chevy Astro van 1999?

Remove the positive battery cable from your 1999 Chevy Astro battery. Disconnect the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.


How to change headlamp 99 Chevy Astro Van?

Remove the wiring harness from the back of your 1999 Chevy Astro headlamp. Remove the headlamp retaining bolts. The headlamp will come out. Reverse the process to install the new headlamp.


What is the Spark plug gap for a 1999 Chevy Astro?

.60


Where is the low side service port on a 1999 Chevy astro van?

The AC low side service port on a 1999 Chevy Astro van is located next to the firewall. It is the port that is closest to the evaporator.


Where is the pcv valve on a 1999 Chevy Astro?

The PCV valve on a 1999 Astro should be located on top of the valve cover. It plugs in and can be easily replaced.


Where is the horn relay on a 1999 Chevy Astro?

The 1999 Chevy Astro horn relay switch can be found on the back of the horn. The relay switch will be attached to the horn with two retaining screws.


What is the firing order for a 1999 Chevy Astro?

the firing order is 165432


How many catalytic converters are on a 1999 Chevy astro van?

1


How many gallons in a 1997 Chevy Astro gas tank?

I haVE A 1999 CHEVY astro and it holds just over 25 gallons. once ran out of gas and then had it filled.


How do you replace a rear you joint in a 1999 Chevy Astro van?

Unbolt/remove driveshaft. Use U-joint press to remove old U-joint, install new and replace driveshaft.


Radio in a 1999 Chevy Malibu?

show me the radio in a 2002 Chevy mabliu l s or show me how to set the clock on the radio


Where can you find an engine diagram of a 1999 Chevy astro van?

Engine diagrams can be used as guides when it comes times to making necessary changes. An engine diagram to a 1999 Chevy Astro Van can be found in its maintenance and repair manuals.


How do you install a radio in a 1999 VW Passat?

how do you remove a 1999 vw passat radio


After you remove the door panel how do you change the power window regulator for a 1999 Chevy Astro Van?

Is it bolted or riveted . Drill out the rivets and use bolt on the new motor.


Can the rims for a 1990 Chevy Astro van fit on a 1999 Chevy Astro van?

Yes. The lug pattern is the same on all Astro vans up to 2001. 2002 they went to a six lug pattern.


What is the miles per gallon for a 1999 Chevy astro van?

My 95 Chevy Astro van averages 15 mpg in the city. I do not know what it gets on the highway. It has a 4.3 L V6.


1999 Chevy Cavalier radio hookup?

It is much easier to answer your question if you put it in a complete sentence. What do you want to know about 1999 Chevy Cavalier radio hookup? I need to know the code for my radio, as it is locked out.


Where is the ignition module on a 1999 Chevy Astro van?

Right under the ignition cap.


Have a 1999 Chevy astro van 4.3L that will only start with carb cleaner?

check your fuelpump


Where is fuel pump on 1999 Chevy astro van?

Mounted on top and inside the fuel tank.


How do you remove the spider gears in a 1999 chevrolette silverado?

how do you remove the spider gears in a 1999 chevy siverado?


How do you remove speakers?

How do you remove door speakers on a 1999 chevy tahoe


Does a 1998 Chevy pickup 4l60e transmission match a 1999 Chevy astro van?

Yes it will as long as the 98 trans is not out of a 4x4. SAMETHING


How do you remove the ignition switch on a 1999 Chevy Cavalier?

Remove the retaining ring from the top of your 1999 Chevy Cavalier ignition switch. Slide the ignition switch out and remove the wiring harness from the end of it.