remove the axle nut on the opposite side from the rear drive sprocket. no need to remove the bolt from inside of the rim, just the big nut. then get a hammer and hit the inside of the tire not the rim then the whole wheel will come off. then remove the disk brake remove the caliper first then the disk. then remove the 2 nuts from the axle holding the inside nut and loosening the outer nut. then nicely pull the whole shaft out from the sprocket side. no need to remove the wheel for this step. make sure you remove the chain from the sprocket .. have fun..
Axel Ranisch was born in 1983.
how do you remove the axel after taking out an alternator
Axel Hervelle was born on 1983-05-12.
You will have to remove the rear cover. the service plug is midway up on the passenger side.
Axel Johansson - speed skater - died in 1983.
Axel Cédric Konan was born on 1983-01-25.
jack it up, remove the wheel nuts or if none a carter key under a rubber cap on axel,
36 mm
probably CB axel, is it a honda?
how do you change rear brakes on a 1990 Honda trx 300fwl
depends on type but generally you remove cover ,remove pin locking bolt 5/16" or 8mm ,remove spider pin then push axel inward ,remove "c" clip from axel then pull axel out this allows you to remove gear ball caps and remove gear ball, then pinon comes out through back
take it to a shop trust me