== ==
# Release the parking brake # Remove the cowl trim panel from the left side of the drivers compartment for access to the parking brake pedal # Pull back on the parking brake cable toward the control assembly (parking brake) and insert a 5/32 inch drill bit into the control actuator to lock the assembly into position # Its actually easier to pull the parking brake cable from under the vehicle but you will need an assistant to help you do this way. # Loosen the rear wheel lug nuts and raise and support the truck # Remove the brake calipers and the brake discs # Detach the parking brake cable from the actuator arm # Clean the parking brake assembly with brake cleaner # Remove the brake shoe retracting spring # Remove the adjusting screw spring and remove the adjusting screw # Remove the hold down springs from the shoes # Remove the parking brake shoes from the actuator
2001 #2500 series rubber gromet on backing plate , remove , parking brake adjustment shoud be visable . use brake adjusting tool to rotate star wheel on inturnal parking brake to losen P. brake. then remove brake rotor and pads check P Br. shoes alot of work! mike s.
there are brake shoes in the discs too . just remove the discs and you will see them. they are applied by a cable.
check the parking brake cables, any applied tension, and condition of the brake shoes
They just pull off but parking brake must be released & you may have to tap it. Shoes tend to fit pretty tightly in there.
# To gain access to the parking brake adjuster raise the rear and support the truck # Remove the rubber plug from the brake backing plate and using a screwdriver or brake adjusting tool turn the adjusting screw star wheel until the parking brake shoe start to drag as the disc is turned then back off the star wheel until the shoes dont drag
Remove the tire and wheel from your Mitsubishi. Remove the brake spring and the brake caliper. The brake shoes will come off. Reverse the process to install your new brake shoes.
Remove wheels Remove drums (Make sure parking brake is released Loosen and remove brake lines Remove mounting bolts Slide wheel cylinder out (may have to separate brake shoes slightly) Re-install new cylinders and Bleed new cylinders
Remove the tire and wheel. Remove the brake assembly spring. The brake shoes will come off. Reverse the process to install the new brake shoes.
on my 91 when i put new shoes on i adjusted the shoes out with adjuster until shoes touched drums and that also took care of my parking brake problem --- you may need rear brakes ???
you dont adjust you replace brake shoes
Remove wheel, brake caliper, brake disc, parking brake shoes etc. Drive out broken stud, replace with new stud. Replace above in reverse order.