You will need to remove the tail light covers in the cargo compartment. Remove the wiring harness. Remove the tail light assembly retaining bolts.
Remove the fasteners and electrical connection from behind the assembly and slide the assembly out the front.
drop the tailgate on side of bed where tailgate closes are couple of screws. thses hold the light assembly in bed. remove thse ,then remove light assembly light bulb is the able to be removed from back of assembly
You have to remove the front bumper, remove the headlight assembly. then take the fog light bulb out.
If you look under were the plate is the light is held in by 2 plastic screws just get a flathead screwdriver and separate them and light assembly will come right out
On my 2005 Dodge Ram Daytona. I had to open the tail gate, remove the two screws on the jam next to the light assembly. After removing the assembly, there is a light bar held by six screws. After removal of these, you can select the bulb you wish to change and then reassemble to install light assembly.
Open trunk, there should be a few screws that hold tail light assembly to car. Remove screws and pull tail light assemble straight back.
The lens assembly is held in with two screws. Remove those and the lens will pop out.
Open the hatch door and locate the two screws holding the tail light assembly and pull the assembly out of the housing. Unscrew the cover assembly, remove and replace the bulb. Reinsert assembly and replace screws
should be two screws or bolts from just inside the tail gate area
No, you get an assembly.No, you get an assembly.
there are two screws holding the light assembly to the car. Remove the two and replace after removing headlight
"i believe you have to change the entire fog light assembly." Wrong Answer. Correct Answer: Remove the wheel well splash guard to access the fog lamp assembly. Twist the harness and remove the old bulb. Replace bulb. Twist harness back into fog lamp assembly. Replace the wheel well splash guard. Done.