answersLogoWhite

0


Best Answer

The throttle body on most cars I've seen is fairly simple to remove. You'll need a socket set, and some spanners, and a couple of new gaskets. Go to your local auto parts and ask for the gaskets needed for your throttle body, and you should have no trouble picking them up. First things first, remove the cables (up to 3) from the throttle opener. They should just unclip. Place the ends aside, remembering where they came from. Remove any hoses and wires connected to the body, being careful to label them so they go back to the right spot. Remove any brackets and mounts around the throttle body that get in your way. Unscrew the bolts holding the throttle body to the inlet manifold, then remove. Remove all traces of the old gasket from the inlet manifold. Once the throttle body has been cleaned using carburettor cleaner, reinstallation is the exact reversal of removal, ensuring to replace all the gaskets, and put the hoses, wires and cables back where they came from.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the throttle body to clean it?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How to clean a 2006 trailblazer idle air control valve?

The Trailblazer has an electronic throttle (drive by wire). There is no IAC valve, it is built into the throttle body. Remove and clean the entire throttle body.


Do you need to remove the throttle body to clean it?

A throttle body can be cleaned without removal. Several spray cleaners for throttle bodies are available at your local auto parts.


Where is the Idle Air Control Valve on 2002 trailblazer?

The Trailblazer has an electronic throttle (drive by wire). There is no IAC valve, it is built into the throttle body. Remove and clean the entire throttle body.


1996 jeep Cherokee throttle position sensor location?

It is located on the outside of the throttle body in line with the butterfly. Remove the air intake from the throttle body and it will be accessable on the back side of the throttle body. Easier to work on if you remove the throttle body. Easier to clean it too.


How do you clean the throttle position sensor 2003 dodge ram?

You don't. But you can clean the throttle body with throttle body cleaner. Just follow the directions on the can.


What causes trailblazer to go dead when idles?

If it goes dead when under load like a/c kicks on, then it's highly likey that you need to clean the throttle body. The throttle body is simple to remove. Use throttle body cleaner and clean the back and all ports. Always disconnect the batter before removing throttle body, it will mess up electronic memory if you don't.


How do you clean the throttle body on a 2000 Pontiac Gran Prix?

"How do you clean the throttle body on a 2000 Pontiac Gran Prix?"


Why does throttle stick on your throttle body?

Carbon build up. Clean the throttle body with a good carb cleaner.


How do you clean throttle body and throttle plate 2006 Ford Focus?

no


How do you clean the throttle body on 00 ford ranger 3.0 v6?

clean the throttle body on 20000 Ford Ranger 3.0 v6 is with throttle body cleaner purchased at an auto parts store.


What is the cause of hesitation in a car coupled with a sticking accelaration paddel?

more than likely your throttle body butterfly valves is sticking. you can clean it with throtle body cleaner but you must remove any sensors from throttle body first.


How do you replace a throttle sensor in a 1988 Nissan Sentra?

Is it easy to replace a throttle body in an 88 sentra? How do you clean a throttle body