Begin by removing the washer fluid tank hoses from your 1998 Oldsmobile And tree. Remove the washer fluid tank retaining bolts. The washer fluid tank will come off.
Most of the later GM washer pumps are located at the botoom of the washer fluid container. You will need to remove the tank to get access to the pump.
If you push the fluid button and the wipers move then it is the pump
The 1999 Olds Intrigue does have a dipstick. Use a funnel to add fluid as needed into the dipstick tube.
To remove the shift knob on the 1999 Olds Intrigue look for the pin that is holding the knob in place. Remove the pin and pull up on the knob, replace kob and pin.
Just remove the console and you can get to it.
did you check to see that the washer fluid is full? Open hood and check to see if the pump motors on the washer fluid res. came unplugged. Also see if any of the lines came disconnected from the wipers or the washer fluid tank.
Remove the wheel, the calipers and the rotors, reverse procedure with new rotors.
On the 99 Olds Intrigue, the camshaft sensor is located on the rear of the engine. It is just above the starter.
This is on a 1998 Olds. Intrigue 3800 V6
Under the glove box and air bag. Remove the airbag fuse and disconnect the battery before attempting to remove the blower motor.
The windshield washer pump on an Oldsmobile Aurora is typically located near the reservoir for the windshield washer fluid. In most models, you can find it mounted on or near the bottom of the reservoir itself. To access the pump, you may need to remove the reservoir from the vehicle, as it is often integrated into the assembly. Always consult the vehicle's service manual for specific details and guidance.
Only the Olds Intrigue with the 3.5 L