on the air cleaner box to the right disconnect wire harness it pulls off. but mine was on the air cleaner box.
The intake air temperature sensor for a 2003 Saturn Vue is on the engine block. It is mounted near the top on the driver's side.
There is NO Mass Air Flow sensor. There is an Intake Air Temperature Sensor located in the air box inlet
The intake air temperature sensor can be found on the top of the air intake manifold. The temperature sensor should be labeled as such.
The IAT (Intake Air Temperature) Sensor is a Two (2) Wire sensor located close to the intake.
The air intake temperature sensor can be found on the top of your manifold intake. The sensor will be right in the middle of the intake manifold.
Should be mounted on the intake under the engine cover. NEW ANSWER: The AIT sensor is part of the mass air flow sensor on that year. Must replace MAF sensor to repair the AIT sensor. NEUTZ
The i.a.t intake air temp sensot is located in the air intake it is the plug that hooks right into the air tube but it is also the maf mass air flow sensor just so you know
The intake air temperature sensor is located on top of the intake. In a 1990 Toyota Camry the air temp sensor assures the ECU the engine is running at optimal temperature.
P0113 Intake Air Temperature Circuit High Input check the intake air temperature sensor and wiring for problems. And you can take a scan tool to repair it, I think the Nissan consult3 is a good choice.
The air intake sensor is located in the air tube connecting to the air cleaner box. The tube runs driver's side to passenger's side at radiator location and is on the bottom side of the tube. Make a note.....the coolant temperature sensor and air intake sensor are the same.
Code P0113 indicates a intake air temperature sensor circuit high output. Check the connection to the intake air temperature sensor and if that is fine consider replacing the intake air temperature sensor.
an intake air temperature sensor is a sensor that is used to measure the temperature of the air that flows through your intake manifold into your engine.it is usually posisioned on the intake filter housing.