for just a cv joint u need to get a center punch and tap the indent on the nut out so you can loosen the nut in the center of the wheel. Jack the car up and put it safely on blocks as a jack by its self will be unsafe as you can knock the car around alot. Then remove the wheel. remove the break calipers (be careful not to damage the flexible break line). then remove the center nut all the way. undo and remove the 2 bolts that attach the hub to the suspension. now the hub should be able to move freely around to the rear side of the car. you should be able to push the cv joint out of the hub with abit of effort (be aware that it may be rusted in, so spray it with degreaser and give it gentle taps with a mallet. Be AWARE that if you hit it too hard you may damage the bearing). now if just replacing the cv joint and not the drive shaft, remove the rubber boot and tap the back of the cv joint towards you with a with a mallet (be carefull not to hit your self). put the new cv joint in and do the above in reverse. also if you have some graphite grease on hand rub abit on the splines that go into the hub to make for easy removal down the track, as they can rust in place. (remember to fill the new cv with grease and to top up your gearbox oil) To do the whole shaft just do the same but instead of removing the boot you should be able to pull the shaft out of the gearbox with short, sharp, powerful bursts. If not you will need to use a crowbar in on the inner cv joint where it goes into the gearbox to pop it out (this can take abit of effort so make sure the car is secure on its blocks and heave lol). Note: when you take the cv shafts out check to see if the screws on the break disc are not loose. if they are remove one screw and put locktight on it then put it back and repeat with the other. Hope this helps Brian
Zappa66@hotmail.com
It is best to replace the whole axle, Its easy to do not to mention pretty inexpensive....
how to replace u-joints on 1995 ford ranger 2wd
Replacing Ball joints Check Related Links Below
very carefully.
with blinker fluid
The CV joints on a 1995 Ford Taurus can be replaced by removing the front tires, and the nuts on the lower ball joint. Next, the lower ball joint will need to be removed and the CV joint can be removed.
Ford Festiva was created in 1986.
please answer my question on how to replace ball joints 2007 ford sport track?
You can't repair it you can only replace it.
just buy a new one and replace it
Get a manual from DISCOUNTAUTOREPAIRMANUALS.COM for about $9
How do you get the door trim off a 1997 Ford Festiva?"