answersLogoWhite

0

What else can I help you with?

Related Questions

Where is the ignition control module located on a 1990 Oldsmobile Cutlass Calais?

Is the Claias 2.3L 2.5L or 3300?


How do you replace starter 1990 750il BMW?

where is the starter


Where is the starter on a 1990 Oldsmobile 88?

The starter is located in fromt of the car on the bottom. Follow the red wire from the battery.


How do you replace a 1990 Oldsmobile cutlass ciera starter?

You start by disconecting the negative - battery terminal. climb undre the car and dixconect the 2 whires going to the starter. Then unbolt the starter from the transmission. replace is the same way, just oppisite. If you don't even know where the starter is than, follow the positive battery cable till it stops. that is the starter.


Were is the oil filter on a 1990 Oldsmobile calais Quad 4?

he oil filter is towards the front of the engine near the oil pan


How do you find the location of the flasher fuse in a 1990 Oldsmobile Cutlass Calais?

the library should have a shop manual for this vehicle, you can make copies of the right sections :)


What would cause 1990 V.W. cabriolett to spin starter but not start?

You need to replace the starter.


1990 Oldsmobile Calais dies when put into any gear and rough idle?

its the kick down solenoid on the transmisson try replacing egr valve or pcv valve


Where is the starter located on 1990 Oldsmobile Delta 88?

Front, lower drivers side of engine, between radiator and engine.


What hex drive does one need to remove the calipher from a 1990 oldsmobile cutlas Calais?

To remove the caliper from a 1990 Oldsmobile Cutlass Calais, you typically need a 3/8-inch hex drive (sometimes referred to as an Allen wrench) to access the caliper mounting bolts. It's advisable to double-check the specific model and any modifications that might affect the fasteners used. Always ensure you have the correct tools for a safe and effective removal process.


On your 1990 Nissan 4wd hardbody sometimes you have to hit the starter with a 2x4 for the truck to start. What is the problem?

Starter solenoid sticking. Replace the solenoid if it is external. If it is internal, then just replace thee starter. It will cost a little more but you will have a new starter and solenoid.


How do you fix the signal lights if they are not flashing on a 1990 98 Oldsmobile Regency?

first thing to replace would be the flasher can