CV Joints
Ford Escape XLS
Ford Escape XLT
Chevy Cavalier Z24

How do you replace a CV axle on a 1988 Chevy Cavalier Z24?

Top Answer
User Avatar
Wiki User
Answered 2006-11-23 14:40:50

i would just get the entire drive axle..do it your self, it may ba alot cheaper.Hope this helps

User Avatar

Your Answer

Still Have Questions?

Related Questions

How do you replace the speed sensor in a 1988 Chevy Cavalier?

the speed sensor is located on top of the transaxle near where the right side drive axle is attached . remove the two wire electrical connector and the retaining screw and pull it out. reverse the procedure to install.

Where is the fuel filter located on a 2004 Chevy Cavalier?

It is located right above the rear axle.

How do you replace the axle on a 1986 Chevy Celebrity?

Please clarify your question as in front or rear axle.

How do you remove rear wheel bearings on a Chevy Cavalier?

Remove the tire and wheel from your Chevy Cavalier. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing.

Where is the speed sensor on the 4t40 automatic transmission for a 98 Chevy Cavalier?

Where the passenger side CV axle enters the transmission.

Where is the fuel filter located on a 1999 Chevy Cavalier Z24?

The fuel filter is located just above the rear axle.

What is the torque on a 2000 Chevy cavalier axle nut?

185 to 260 ft lbs this is the front center nut that holds axle and front wheel bearing together not wheel lug nuts

Is it recommended to replace rear axle seals but not the bearings on a 1996 Chevy S-10 4wd?

It would be recommended to replace the rear axle bearings and axles when they are worn/bad. If the bearings and axles are okay, just replace the seals.

What is the cost on replacing a drive shaft in a 2000 Chevy cavalier?

The axle generally goes for 160.00 plus labor of about an hour. or cheaper if you have the tools to do it yourself.

How much will it cost to put an axle im your cavalier?

the Chevy cavalier does not have a drive axle, it has cv (constant velocity) shafts, which are faitly expensive to have replaced, but the part itself is not terribly expensive, my dads 2003 Mazda protege's shaft was $140 Canadian, just don't go through your dealer they charge way more ($480 in this case) but they take quite awhile to replace so the labor costs are quite high

How much will is cost to replace a cv joint on a Chevy Cobalt?

If you replace the entire cv joint axle in MD you will have $82 in the new axle + labor in a garage $40-$60 per hr. I did it myself. not a bad job.

Where is the starter located on the 1990 Chevy cavalier Z24 3point 1 L?

Under the motor running parallel to the front axle. It is round about the size of a small coffee can.

What size is the axle nut on a 2003 Chevy cobalt?

what size is the axle nut on a 03 chevy cobalt

How do you replace a CV boot on a 2000 Chevy s10 4x4?

It is way easier to replace the whole halfshaft. Espiacially if you have never done a bot on this type of axle shaft.

How do you replace a rear axle on a 2003 Chevy silverado?

is it a posi rear end? big difference bteween them for procedure. yeah its positive

Do you have to drop the tank to replace fuel pump in a 1988 firebird?

You have to lower the rear axle, remove the exhaust system, and drop the tank.

How do you replace a axle on a 95 olds cutlass supreme?

How do you replace a axle on a 95 holds cutlass supreme

How do you change backing plates on a Chevy Trailblazer?

You must remove the axle to replace the backing plates. It is job for the professional do-it-yourselfers with all the tools.

Still have questions?

Trending Questions
What times 10 equals to 1000? Asked By Wiki User
How old is Danielle cohn? Asked By Wiki User
Previously Viewed
Unanswered Questions