Much better to replace the whole axle, look at www.happywrenching.com for a guide on how to replace an axle in a Honda Odyssey
The left CV joint can be replaced on a 1989 Honda Accord by removing the left tire and the moving the brake lines. Next, the ball joint and the tie rod should be removed, which will allow for their to be enough room to use a pry bar against the transmission which will pop out the CV joint.
how do you replace a CV joint on a 1992 Chevy pickup?
how do you replace the drivers side drive shaft and cv joint?
don't replace the joint. replace the axle
Replace the complete halfshaft assembly, it is much easier than trying to replace the cv joint itself.
90 honda
The CV joint in a 2000 Kia Sportage can be replace by roving the tires, axle nuts, and the knuckle bolts on the struts. Next, the CV joint can be removed by placing a screwdriver between the transmission and the CV joint will pop out.
To pull the outer CV joint on a 1996 Honda FourTrax ATV to replace the boot, first, remove the wheel and brake caliper, then disconnect the axle nut using a socket. Next, use a hammer or a CV joint puller to tap the joint off the axle shaft, taking care not to damage the splines. Once removed, you can replace the boot and reassemble the joint by reversing the steps. Be sure to use new grease and securely fasten all components during reinstallation.
Begin by removing the tire and wheel from your 1987 Honda. Remove the brake assembly and the brake rotor. Remove the CV joint retaining bolts. Reverse the process to install your new CV joint.
How much does it cost to replace a cv joint on 4 wheel drive
If the CV boot is torn open forget about re-booting the joint, buy a remanufactured axle and replace it. If the boot is starting to crack or separate but has not torn open to the point you can see the cv joint itself you can re-boot it.Replacing CV JointsThere are places that sell the halfshaft axles already rebuilt as cheap as you can replace the joints. Call your local parts stores.
To replace the outer CV joint boot on a Honda ATV, first, lift the ATV and secure it on jack stands. Remove the wheel and axle nut, then disconnect the axle from the hub and pull it out. Carefully cut off the old boot and clean the CV joint, then apply new grease before sliding on the new boot. Finally, secure the new boot with clamps, reassemble the axle, and reinstall the wheel.