How do you replace a fuel pump for a 1998 Camaro?

Answer 1

"It is a very huge job. Release the fuel pressure. Raise back end of the vehicle and support with jackstands. Drop down the rear with a floor jack underneath the pumpkin. Remove the rear section of the exhaust system. Open fuel door and remove fuel filler screws. Remove the straps holding the gas tank. Find out where the fuel lines are connected and disconnect them. Take out the gas tank and then remove the fuel pump from the within the gas tank. There is a c clip holding it in place. Remove that clip by tapping it off with a flat head screwdiver and a hammer. Then put in the new fuel pump." ...Or, do this. First you'll need a dremel. Now go behind the rear passenger seats and lift the carpet. It shouldn't be glued down or anything. If so gently pull up on it. Directly in the center of the open space of metal now revieled, use the dremel to cut a small square to locate the fuel lines and 5 nuts. These lead to the pump which is strait below were you should've cut. Now located, cut a larger square for room to remove the nuts and lines from the top of the pump. Once fuel lines are disconected and the nuts removed, GENTLY lift the pump out of the tank. Once done, you can see the actual tank which is the metal cylindrical thing at the bottom if not incased by a tan casing. There you go, now you may replace the pump or look for problems.