To replace the knock sensor on a Toyota T-100, first disconnect the negative battery terminal to ensure safety. Then, locate the knock sensor, typically found on the engine block, and remove any necessary components blocking access. Unscrew the old sensor using a socket wrench, install the new sensor, and reconnect the wiring. Finally, reassemble any removed parts and reconnect the battery.
How do you remove taillight cover on a T-100 toyota Truck
it's up under the intake. just take it to a shop because it is a pain to do yourself. it's worth paying someone $100 to do it. trust me.
The cost to replace the oxygen sensor in a 2002 Toyota Sienna typically ranges from $100 to $300. This estimate includes parts and labor, with the sensor itself costing between $50 to $150, and labor fees varying depending on the mechanic's hourly rate. It's advisable to get a few quotes from local repair shops for a more accurate estimate based on your specific location.
The price is around $50 to $100 for the sensor and about 30-40 minuets to change when cool.
About $185 at the dealer (one sensor). About $100 at a parts store; cheaper on-line if generic. People report that generic sensors fail prematurely; go Nippon denso for quality (factory part).
The cost to replace an oxygen sensor on a 2002 Toyota Avalon typically ranges from $100 to $300, including parts and labor. Parts alone can cost between $50 and $150, while labor may add another $50 to $150 depending on the shop's rates. It's advisable to get quotes from multiple mechanics for the best pricing.
Are you sure that you need to replace the knock sensor. I have a 1996 G-20. It had 3 check engine codes. #1 was knock sensor, #2 was Egr valve, #3 was O2 sensor. I performed some testing and then replaced the EGR and canister control solenoid. It is located on the back side of the engine and is somewhat accessible from below. After it was replaced all 3 codes cleared within one week. A new unit was $100 from the dealer. It is possible to repair the old one if you are technically and financially inclined. step 1 test egr valve and the vacuum valve attached to it. step 2 remove the Egr and canister control solenoid valve. Test it by blowing air through it and then applying 12 volts to the solenoid. If the air flow does not change it is stuck. Replace or repair it.
any were from a 100 dollars to 300 dollars. any were from a 100 dollars to 300 dollars.
i have the same code i search on the internet and i found that is the MAF sensor (mass air flow sensor) clean it or replace it it cost about 100
You replace the wheel bearing hub assembly - it has studs, bearings and wheel speed sensor around $100 part
Anywhere from $30 to $100 depending on year and who you purchase the part from.
I would expect $100-150.