Back of the engine block. 3 bolts to release and ridiculously hard to reach.
On the back of the engine block. 3 bolts to take it off, easy to do but hard to reach.
how do I disconnect the Electrical connection on knock sensor
how to replace a knock sensor on a 2000 Chevy 6.0 step by step
how to replace a knock sensor on a 2002 hyundai elantra
The 4.8, 5.3 and the 6.0 GM engines require removing the intake manifold to replace a knock sensor.
Where is the knock sensor for a 2003 kia spectra
how many gaskets and which ones are needed when you replace the knock sensor on a Nissan frontier w/a 3.3l v6 engine?
you have to remove the intake, and there are 2 knock sensors.
If just the knock sensor need to be replaced. I would say no more than $150.00
Inspect the wiring to the bank 2 knock sensor, if the wiring looks okay replace the bank 2 knock sensor.
need change knock sensor 2 bank 2 in 2000 lexus rx300
There's no need to replace knock sensors, and there was never a 3.6 engine.
You need to test/replace the knock sensor. ireplaced it already.
The 1997 Saturn knock?æsensor is located on the back of the engine. The knock sensor can be removed by removing the wiring harness and the retaining bolts.
The knock sensor has failed and you need to replace it with a new one in order for the check engine light to go out.
The knock sensor on Nissan 300ZX non-turbo from 1990 thru 1996 is located below the lower intake manifold on the rear of the engine block. To replace the knock sensor the upper and lower intake manifolds need to be removed. It is always best to replace the knock sensor with a new one considering its major dissasembly.
a swivel socket
Not until it starts giving you trouble.
The knock sensor for most Nissan V6 engines is located directly under the intake manifold. So to replace it, you have to remove the intake manifold. Good Luck.
the knock sensor is located under the intake manifold, with a flash light you can see it however you have to remove the intake manifold to replace the knock sensor , also you will need to replace the intake gasket set as well!
The knock sensor for a 3.5 Honda engine is located on top of the motor under the intake. It is about a 1.5 hour job to replace it.
You shouldn't have to - the knock sensor is supposed to adjust the timing automatically. If the vehicle is mistimed, you might need to replace the knock sensor.
The knock sensor for a Pontiac G6 is located on the side of the engine. It is mounted at the exhaust manifold.