You need to take off the dashboard,to get at the instrument pod.There are two screws hidden under plastic covers,at either end of the dashboard,nearest the door.And a number of screws to be removed under the dashboard,in the footwell area.release the steering wheel adjuster,allowing space to remove the dashboard.Making sure you disconnect the speaker leads at the same time.When you have removed the dashboard,there are two clips holding the pod in place,and two connecting plugs that have to be removed.The bulbs are in the back of the pod,and a twist fit,easy to take out.reverse the procedure to re-assemble.
Usually at the base of the brake pedal.
The recommended oil grade is 10W/30.
Any good make of 10w-40 oil
replace the starter
when engine running , i took out msf sensor accidentally. Then lambda on ,
The dial for the dash lights is very sensitive,you have to keep turning the. Dial up and down get the light to go on.when if does go on the light is very week.
To replace the AC relay in a 1995 Volvo 940, first locate the relay, which is typically found in the engine compartment fuse box. Remove the relay by pulling it straight out of its socket. Replace it with a new relay, ensuring it is seated properly in the socket. Finally, test the AC system to ensure it is functioning correctly.
To turn off the daytime running lights on a 1995 Volvo 940, locate the fuse box under the dashboard or in the engine compartment. Remove the fuse labeled for the daytime running lights (usually marked as fuse 4 or 5, but check the owner's manual for the exact location). This should disable the daytime running lights. If you're unsure, consulting a professional or the vehicle's manual is recommended for further assistance.
where is the idle control value on a 1995 cadillac sedan deville
Try the fuse and then the bulbs.
To replace the brake pads on a 1995 Volvo 850, start by safely lifting the vehicle and removing the wheel. Next, remove the caliper by unbolting it from the bracket, then slide it off the rotor. Take out the old brake pads and replace them with new ones, ensuring they are properly seated. Reattach the caliper, tighten the bolts, and repeat on the other side, then reinstall the wheels and lower the car.
My service ride control appears on the control panel of my 1995 Cadillac SLS Sedan Seville.I need to know what it looks like and where it is located on the car to replace it?