answersLogoWhite

0

How do you replace drive shaft 2000 Chevy Blazer?

Updated: 10/23/2022
User Avatar

Robertmaryannlee

Lvl 1
14y ago

Best Answer

I have a leak on my drive shaft left front 2000 cheve Blazer I would like to replace the whole unit

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace drive shaft 2000 Chevy Blazer?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can a transmission from a 88 Chevy Suburban 4wd fit a 92 Chevy blazer full size 4wd?

yes but you would have to replace drive shafts. The 4x4 shaft is shorter due to the transfer case.


How do you take the 4 wheel drive off on a 1989 Chevy Blazer?

you dont, if you want to disconnect it then remove your front drive shaft.


Where is the cam shaft sensor on a 2001 Chevy Blazer?

nic


Can a transmission from a 90 Chevy suburban 2wd fit a 92 Chevy blazer fullsize 4wd?

No it will not. The center shaft that run's through the inside of a 2 wheel drive trans. is shorter the the center shaft that's in a 4-wheel drive trans. The 4-wheel drive transmission center shaft is longer so it will fit into the transfur case.


How do you replace the rear wheel seal on a 1992 Chevy blazer?

You have to open the differential and remove the retaining pin from the spider gear to remove the axle shaft.


Can you replace a universal joint in a 2003 Honda CR-V or do you have to replace the whole drive shaft?

You have to replace the whole drive shaft.


How do you replace drive shaft on 1990 Toyota Camry?

tool for drive shaft


Where is the crank shaft located on a 2000 Chevy blazer?

Inside the bottom of the engine block.


Where is the cam shaft position sensor on a 2000 Chevy Blazer V6?

Next to the distributor


Do you have to change the drive shaft when you replace the drive shaft oil seal on a 2006 Nissan navara?

No you do not.


Why does front drive shaft rotate on Chevy blazer 4x4 2002 when elctronic switch not engaged?

there could be more than one factor it sounds like the actuator is bad or if your blazer has partial vacumm control then you could have a vacumm leak


Will a transmission from a 1983 4X4 S10 blazer work in a 1986 2wheel drive S10 blazer if you change out the tail shafts.Both are 2.8 liter?

The shaft inside the trans will have to be changed it is longer in a 2 wheel drive and the taIL SHAFT.