answersLogoWhite

0

after you take off the tire there are two bolts that connect the caliper to the wheel bearing loosen those up and the caliper will comne right off once you have done that then you have to depress the caliper so that you can get the old pads off there is a c clamp that you can find at any auto parts store that will help with that after you take off the old pads put the new pads in make sure that you slide them in the right way and then just reverse everything that you have already done.don't forget to take the lid off of your brake fluid reservoir so that you donmt get air in your lines

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you change the front brakes and the back brakes on a 1999 Alero Oldsmobile?

First of all, Do you have any specialty brake tools? Ben


How do you replace the head lights on my 1999 Oldsmobile alero?

how do you replace head lights on my 1999 oldsmobile alero?


How do you change front brakes on a 1999 Pontiac grand am?

I have a 99 grand am and I am tring to replace the brakes on the front of my car but when I go to put the brakes back on the caliper wont line up wheats wrong with this? How do I fix this?


How much to replace 1999 alero water pump?

200.00


How do you replace the oil pump on a 1999 Oldsmobile alero with a 3.4 liter V6?

how do you replace the oil pump


What could cause a 2001 alero to squeal as if the brakes are bad but only when you turn left or right?

In my 1999 Alero, it did this and it was traced back to the power steering pump going bad.


What type of rear brakes are on the 1999 Ford Explorer?

disc brakes - front and rear


How do you replace rear brakes 1999 dodge 1500?

i need a diagram on how rear brakes are assembled


How do you change brakes on 1999 Honda civic?

front or rear


How do I replace the front strut on 1999 Saab 9-3?

how do i replace the front strut on 1999 Saab 9-3


Where is the alternator located on a 1999 Oldsmobile Alero 4 cylinder?

On a 1999 Oldsmobile Alero with a 4-cylinder engine, the alternator is located on the front side of the engine, near the top, slightly towards the driver's side. It is mounted on the engine block and can be accessed from the top of the engine compartment. You may need to remove the serpentine belt to replace or service the alternator.


How do you replace the front brake pad wear sensor wire on a 1999 Mercury Cougar 25L?

http://www.carquest.com/techbulletins/brakes/2001/CQB%2001-10.pdf