Take the window winder. Note , there is a meta clip to release the window winder.
Unscrew the Philips screw in the door holder. Unscrew the torx screx behind the dor lever. And pop the door panel out.
Unscrew the speaker out.
reverse to install.
You can put the 2003 bumper on a 2002 car, but you will also need to replace the headlights with those from an 03-05 Neon and replace the hood with that of an 03-05 car.
It is a relatively easy job to replace your speakers depending on where they are located.
The front speakers for this car is 4 by 6, no matter if your car is 2 or 4 doors.
Neon lights are not illegal if they are under the car and not distracting. If they are on the back or front of a car, they are illegal.
They seem like speakers are speakers for every car as long as you buy the right size. Check out this site: http://www.howtodothings.com/automotive/a3043-how-to-replace-or-remove-car-speakers.html
The speakers were all recalled due to a vibration in them. Take it to the Jeep dealership and they will replace all the speakers in the car at no charge.
Yes, all you have to do in this circumstance is reconnect the speaker cables to the speakers.
dude go to the library and go to the car Manuel books part and get a book with 2003 cars on it and it will tell you
That really depends on the kind of car you have, but you should be able to go in through the rear armrests and plug the rear speakers into the old front speakers. Most people have speakers in both the front and back of their cars. The order of installation is not important, just have it done the most convenient way for you. You could even omit the front speakers entirely if you wished. Electronically it does not matter.
You will have to remove the door panel to get the front speakers but the rear are accessible through the trunk. On my daughters car I removed the window crank and popped the panel fasteners off the bottom of the door and was able to replace the speaker without removing the whole panel.
front dash tweeters- 3.25" door speakers- 6.5" rear deck speakers- 6x9"
Reach underneath the front of the car, twist the assembly counter clockwise (about 1/4 turn). The bulb and the wires will dangle attached to each other. Disconnect the wire from the bulb and replace the bulb. Reconnect the wiring harness and bulb to the car.