You need to remove the entire spendle assembly. Lay it on an open vise and with a correct size rod, from the inside, drive the center out until the rotor and outside bearing drops out. Do not disturb the bearing. Remove the four bolts from the rotor, which you can now get too and the rotor will come off. Replace the rotor with a new one and lay the spendle assembly on a hard surface and carefully drive the shaft back into the spendle. If you have a "slide puller" you can actually remove the assembly while the spendle is still on the car.
It is best to replace the whole axle, Its easy to do not to mention pretty inexpensive....
In fact it' a 1993 festiva standard. How put off old plates on front discs braques?tancks!Constant
11.5 inches. They are not interchangeable with Twin Cam brake rotors, nor are front and rear '93 rotors interchangeable with each other.
very carefully.
The thermostat is at tje engine end of the upper rad hose, When replacing it make sure the spring goes toward the engine.
4x6 hard to replace!!!
Is your PCV valve working okay?
5.0 Litres (5.3 US Quarts)
Engine, not motor... there is a difference. The engine in the 1993 Ford Festiva/Kia Pride/Mazda 121 was the fuel injected 1.3 liter Mazda B3 engine.
too much
Front is easy, just replace hub rear is pressed in
underneith the front bumber twist counter clockwise replace bulb