Remove the outside Wiper Blade ( nut under cover & pry loose ). Then open rear hatch. Take screws out of pull handle & bottom corner of panel, then pry bottom cover loose from vehicle, being careful about pulling wire from auto open button.
There will be 4 bolts holding the wiper assembly & brake light assembly. Remove these after unplugging the brake light & wiper motor.
Pull assembly away from glass, then pull red lens away to access the bulb.
It is time comsuming but not TOO tough. Just make sure to remember how everything came off to re-assemble.
This is usually cause by a stuck brake light switch on the brake pedal. Replace it.
Why ? Just replace it.
Just unscrew it.
Just unscrew the rear brake light, turn out the socket, and replace the bulb.
Its a whole led unit replace whole deal not bulb
check your brake lights if they not worhing replace fuse or brake light switch
Remove the wing nuts from inside the trunk, the assembly will pop out.
An issue relating the transmission.
To replace the brake light on a 2000 Ford Explorer, remove the screws holding the brake light in place. Gently, but firmly, pull the brake light out of the vehicle and replace with a new one.
How to replace a brake light on a nissan Tiida hatch back.
To replace your brake light, you need to unscrew the brake cover from the inside of the trunk. Then you will be able to pull the old bulb out and replace it.
'P'arking or emergency brake