answersLogoWhite

0


Best Answer

Remove the ignition module retaining ring. Pull the ignition barrel out. Remove the wiring harness from the back of the ignition barrel. Reverse the process to install the new ignition module.

User Avatar

Wiki User

โˆ™ 2014-06-27 21:44:41
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you replace ignition module in a 98' Malibu?
Write your answer...
Submit
Related questions

What causes a anti theft system light to come on while driving in a 98 Chevy Malibu?

When an anti theft system light comes on while driving a 98 Chevy Malibu, the problem is usually caused by the Security Module. The security module is part of the Ignition Lock Module.


What causes no spark on a 98 Chevy 25004x4?

Ignition module bad.


Can you bypass the security ignition on a 2005 Chevy Malibu Classic?

I did it on a 98 Malibu by buying a remote starter and having it installed at car toys.


Where is the ignition control module located in my 98 Chevy Venture?

under the coil pack or on the distrbutor


Numbering ignition 1998 Mazda 626?

How do I replace ignition wires on my 98 Mazda 626 2.0L


Where is the ignition module located on a 98 dodge ram?

The engine computer is located on the passenger side of the firewall.


How much does it cost to have a ignition key made for a 98 Chevy Malibu?

about $1.50 if you have a spare key that they can cut a new one off of.


How do you replace the ignition switch 1992 Oldsmobile 98 regency?

this site is great


Show you how to replace ignition coils for a ford Expedition 2003?

98 expedition


How do you replace an ignition module on a 1995 Oldsmobile Aurora?

Its on the top of the engine at the right front... coils and ignition module are together. Follow the plug wires, away from the spark plugs, where they will connect into the coil pack. The ignition module is sandwiched under the coil pack. To remove either... remove the three nuts under the ignition module and the six torx screws on top of the coil pack.... voila. After market new modules (10/2010) cost $98-134 at Carquest Auto Parts. OEM Delco module cost New from B&B Auto parts $ 360 Good Luck


Where is the ignition module on a 1993 Cadillac ElDorado and what does it look like?

Referenced from 'Chilton 28540 Deville/Fleetwood/Eldorado/Seville 1990-98 Repair Manual' Page 2-10: "Ignition Module The HEI Module, acting as an electronic ON/OFF switch controls the current flow in the primary winding of the ignition coil. This switching action induces a high voltage in the ignition coil secondary winding which is directed through the rotor ans secondary leads to fire the spark plugs. It is not necessary to remove the distributer from the car. 1. Remove the distributer Cap 2. Remove the rotor" This is the Ignition module. Don't remove or replace unless you understand how and know the procedure for changing.


98 Chevy Malibu the ignition wont turn off all the way is there a cheap way of fixing it?

No i have a 2002 malibu that had the same problem when i checked it was the park lock switch that was causing it


Why would a 1990 olds 98 lose power while going down the road then die and start up again drive a little more way then die and not start again?

Ignition module, ECM, ignition coil are all resonable suspects. Ignition module, ECM, ignition coil are all resonable suspects.


How do you replace starter on 98 Kia Sephia?

To replace a starter on a 98 Kia Sephia, turn off the ignition and disconnect the negative and positive battery cables.ÊDisconnect all the bolts that hold the starter to the block and replace with new.Ê


Is gas tank easy to repair or replace on a 98 Malibu?

fairly simple to remove and replace. most shops can remove in 30 min or less.


Little spark on cylinders 1 and 4 on a Chevy s10 with a 4 cylinder?

You didn't say what year but if it is a 98 the problem may be one of the coils is bad or the ingition control module may be bad. You could switch the two coils and see if 2 and 3 now have spark and 1 and 4 don't. If so replace the bad coil. If no change replace the ignition control module.


How would you replace a ignition key if you lost the only one on a 92 olds 98 regancy?

A dealer can look up the ignition codes to make a key if one needs to be replaced on a 1992 Olds 98. A locksmith can also help but the ignition cylinder has to be removed.


How do you fix your automatic windows on your 98 Malibu?

The 1998 Chevrolet Malibu automatic window fuse is located in the fuse box. The fuse box is in the engine compartment. Replace the automatic window fuse.


How do you replace ignition coil on 98 ford crown vic?

you have to replace your spark plug wires there is a coil on each wire for each cylinder.


How do you adjust the timing on 98 gmc safari van?

The distributor is located in a fixed, non-adjustable position. Ignition timing is preset and cannot be adjusted. Ignition timing is controlled by the powertrain control module.


How to replace ignition switch in a 98 Kia Sportage?

I need to replace the ignition switch on a 1998 KIA Sportage . Can this be done with a universal ignition switch ? There are 6 sets of wires going into the KIA switch. The universal switches come with 3 or 4 posts.


Will 1998 Malibu wheels fit a s10?

wondering if 98 chevy malibu wheels will fit a 98 gmc sonoma?


Can you adjust ignition timing on a 98 Ford Ranger 3.0 liter?

Yes ANSWER No - a 1998 3.0 L Ford Ranger does not have a distributor which would allow you to adjust the ignition timing - it has a coil pack and the ignition timing is controlled by the PCM ( powertrain control module )


What parts will interchange with 98' Malibu?

Go to the junkyard and ask them for the part you need and have them look it up in the hollander book to see what other cars that have the same part that will fit your malibu.


How will a wet distribotor cap affecta 98 Pontiac grand am?

There is no dis. cap. GM uses a ignition module and coil pack that sits on top of module. Quad 4 eng. is basicly the same, just a different configuration.