0
You have to pull the stearing wheel, once that is out of the way there is the turn single switch, remove that, under it is the stearing wheel locking plate. It has a pin that comes up though one of the holes, that's what locks the wheel. Push the pin down, it's spiring loaded so watch your self. If I remember right it has two screws that holds it in place. Remove the wheel locking plate. There is you switch.
What else can I help you with?
How do you remove and replace the ignition switch on a 1995 Dodge Grand Caravan?
You will need to remove the retaining ring at the top of your 1995 Dodge Grand Caravan ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
Why does your key not turn in your ignition in your 1990 dodge ram van?
Bad ignition switch or wrong key.Just replace with new switch about $10.00 NAPA
Why would ac blower motor and power windows only work when ignition switch is partially engaged on 2001 dodge ram 2500?
The ignition switch is bad. Replace it.
How do you fix an ignition switch in a 1994 Dodge Vam Ram 250?
Just replace it, it's not expensive.
How do you remove a key that is stuck from the ignition of a 1996 Dodge Caravan Steering wheel is not locked and cannot start the vehicle?
You can't, you have to replace the ignition switch
Where is ignition switch of 2000 dodge ram 2500?
A retaining clip holds the ignition switch in place on the back of the ignition cylinder on your 2000 Dodge Ram.
Why does your 95 dodge neon the ignition turns part way then stops It worked 5 minutes ago?
If the ignition on the 95 Neon will only turn partially, then the ignition switch has gone bad. The only remedy is to replace the switch.
How do you remove and replace ignition switch 1983 Dodge D150 pickup?
You have to remove it gently and go to auto zone and turn it in
Can a 440 fit in a 1974 dodge powerwagon?
Yes
Can fit a 440 in your 1974 dodge powerwagon?
Yes
How do you change iginition switch on 93 dodge caravan?
how do caravanu change ignition switch in 93 dodge
How do you replace ignition switch in 96 dodge ram pickup?
You would have to disconnect the wires from the stock ignition, so you would have to tear it out unless you could find a way to do it without it.
