You can replace just the ball joints on the lower control arms , but the upper ball joints come with a new control arm
how do you replace seatbelt retractor on a 2000 chevy blazer
To replace an ignition switch on a 2000 Chevy Blazer remove the lower steering column and dash. Locate the ignition switch and pull the end-clip off the main harness. Remove the mounting screws from the ignition cylinder and replace the unit.
You need to have a "Ball joint press".
Lower ball joints wear out early. Door hinge pins and bushings wear out early. Idler arm and pitman arm joints wear out early.
Yes there is.
I have a leak on my drive shaft left front 2000 cheve Blazer I would like to replace the whole unit
how do you replace ball joints on a 2000 envoy
You get a pro to do it.duuuhhhh
jack up the car front end removed the tires remove the lower control arm
Replace upper and lower ball joints. Not hard, but time consuming.
you take it toa shop and pay $926.00. that includes allighnment
They did'NT make the Trailblazer in 2000 might you be looking for information for a 2000 Blazer.
read the manual
The 2000 Ram had u joints, not cv joints at the front axle.
It goes to the water pump.
11 ft lbs
Yes you do. There is no other way.
You can but you still won't be able to get it out.
Ain't no fixin it, you have to replace it with a new one.
Length of back brake line to replace. hole in it between front and back door
An alternator from a 2000 Chevy blazer will fit a 2002 S10 blazer with a little fabrication.
YES you do. That's the only way.
Disconnect the negative battery cable from the battery.
Yes, a 2000 GMC Jimmy hood is compatible to a 2000 Chevy Blazer. This is only on the S10 Blazer though.