0
i was wondering how to change rear brake drums for 1999 Chevy venture
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you change back brake drums on 2004 Chevy venture van?
How do you change rear brake drum on a 2004 Chevy Venture?
Does the venture van have brake shoes?
On The rear if you have drums
How do you remove rear brake drums on 2004 Chevy Venture?
first you have to take the wheels off of the van,and then you have to take the tension off of the brake shoes. Next you will be able to remove the rear brake drums off of the vehicle.You may have to tap them with a hammer to break them free.
What could it be if your 1996 Chevy Corsica makes a grinding noise when you brake?
Pads or shoes worn beyond usable. Replace pads and rotors or shoes and drums as needed.
How do you find out what brake system is on a 1994 Chevy 1500?
Pads on front. Drums on the rear.
Do brake drums need to be replaced after being saturated with brake fluid?
No, the drums can be cleaned with brake cleaner.No, the drums can be cleaned with brake cleaner.
Brake drums on 2003 cavalier?
The front have pads, and the back have drums. If you are needing to replace them, they cost around 60. What is it you needed to know?
How much to replace brake drums?
Depends on the vehicle and grade of drum you want to buy.
How do you take off the rear drums on 1988 Chevy Caprice?
Remove the wheel and tap the drums at back with a 'deadblow' hammer, rotating the drum as you do this. The brake shoes tend to hold drums on.
What do you do if the brake light in your car comes on?
Check that the hand brake is not applied. Check the conditions of your brakes like the drums check if there any grooves or are hot to the touch. If you feel any grooves replaces brakes and lathe the drums or replace the drums aswell.
What year cars or trucks have brake drums with a 5x4.75 bolt pattern and 11 inch inside diameter and 2 inch pads?
1971-72 Chevy C10 rear brake drums have a 5+4.75" bolt pattern with a 11" by 2" brake shoes.
How do you know if your rear drums need replacing?
Brake drums should not be turned beyond a maximum diameter, usually stamped on the drum face. Machining them above the maximum tolerance would subject them to overheating and possible brake failure. Better to replace them with new drums & shoes.
