0
Add your answer:
Earn +20 pts
How do you replace an idler pulley on a 1997 Ford F150 5.4ltr?
Remove serpentine belt. Remove pulley. Install new pulley. Install serpentine belt.
Can you replace your serpentine belt on your 97 Ford F150 v-8 4x with ac to a standard serpentine belt for a Ford F150 without ac as you feel the ac compressor is shot?
yes,a good parts man will give you a belt to bypass your ac.
What is Serpentine belt routing diagram for 1990 Ford f150?
I need the routing for the serpentine belt for 1990 Ford 150?
Where is the drive belt adjusting bolt on a F150?
no adjusting bolt u have a serpentine belt.that has a tension pulley that automatically adjusts if belt is loose, u need to replace belt
How do you relieve tension on the serpentine belt of a 1994 f150 5.0 and is a special tool needed?
Serpentine puller
Can you tighten a serpentine belt on a 1998 V8 ford f150 4x4 and how do you do it?
the belt tensioner does it by itself.short answer no
How do you loosen tension on serpentine belt for 1988 F150?
The tension on a 1988 Ford F150 can be loosened by adjusting the belt tensioner. The retaining bolt is loosened, the tensioner shifted slightly, and tightened down.
1992 ford f150 serpentine belt diagram?
its under your hood with the firing order and distributor order
Where is a serpentine belt routing diagram for a 1994 ford F150?
I need a diagram for a serpentine belt for a 1994 f150 with 5.0 engine I need a diagram for a serpentine belt for a 1994 f150 with 5.0 engine There should be a sticker near radiator shroud that has belt routing. If not stick the belt down past the right side of fan/water pump .put belt on crank pulley then pull back of belt over water pump and then down around power steering pulley and up over compressor pulley. put belt from crank pulley around smog pulley then up to tensioner with back of belt around tensioner and then around alternator pulley.next put rachet and socket(15 mm) on tensioner and pull on it while placing belt under idler pulley.
How do you install a new fan belt on a 1998 Ford F150?
The serpentine belt has a tensioner that you nust pry up to remove the belt. There should be a schematic of the routing of the belt on the fan shroud. If not, draw one before removing it.
1989 f150 and am just wondering what could be causing a squealing from the engine I've already changed the serpentine belt and that helped a little but it stills does it when i step on the gas?
The squeal you speak of is belt related, yes; but it is not the belt. There is a belt tensioner ( the part you had to pull up to remove and replace the belt). Inside this tensioner, the bearing goes bad causing the squealing sound you describe. Replace the tensioner (pulley or assembly) and the noise will go away.
How do you disable seatbelt alarm on a Ford F-150 2004?
How do I disable seat belt alarm for a Ford F150 2004
