0
You will have to remove the transmission and then look inside of the bellhousing and you will see the slave cylinder bolted in with 2 10mm bolts. remove the 2 bolts and slide the slave cylinder off the jack shaft.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you replace the rad hoses on a 1996 Ford Ranger?
How do I remove air from the cooling system of a 95 ford ranger 4 cyl
Clockwise or counter clockwise firing order on a 1994 chev k1500?
clockwise 18436572 #1 cyl on pass side, front
Where is the slave cylinder 97isuzu hombre?
Remove trans to replace slave....Slave is connected directly to throwout bearing in bellhousing... shoot yourself because your new slave cyl is now in the transmission bell houseing and your quick connect hydro line will not fit your newly installed slave cyl. unles you can hand machine that connector ( I did) you will hlf to do the whole proses again may as well put it on the moon,good luck finding replacement for quick connect hydro line
I have adjusted the push rod from the pedal to the clutch master Cyl on my 1991 Mercury Capri. Is there an adjustment at the slave cyl also?
NO
How do you fix a slave cylinder on a 1988 Jeep Cherokee?
Pictures of the steps, especially the "keeper", would be handier than random pictures of Jeeps. You have to drop the transmission, remove the throwout bearing/slave cyl, replace it, re-install the trans, bleed the system.
How do you replace the water pump on a 1995 Mercury Mystique?
Depends if it is the 4 cyl or V6 its a 4 cylinder it is a 4 cyl
Where is the clutch bleeder valve on a 1993 Ford Ranger located?
Some cars have no valve and you have to loosten the line to bleed the cyl. Fill the slave cyl as full as you can get it before mounting it .
How do you time a 4.0 jeep engine 1996?
how to time a 1996 4.0 engine jeep and number one cyl.
Where is thermostat 1996 dodge stratus?
4 cyl, it is where the upper hose hooks to the engine.6 cyl, it is where the lower radiator hose hooks to the engine.
Where is the 92 Chevy Cheyenne clutch bleeder located?
on the bottom of slave cyl,use Allen key
Does a 1996 Toyota Camry 4-cylinder have a timing chain or belt?
'96 Camry (both 4 & 6 cyl) have a timing belt, which should be checked and replace per the vehicle maintenance manual.
How much would it cost to replace a blown head gasket for a 1992 Plymouth acclaim?
4 cyl -650 6 cyl-950 if heads are ok
