disconnect negative battery tml.,remove the plug from the alternator,remove the main battery wire from the stud on the alternator, remove the lock bolt, swing alternator down to remove belt, remove pivot bolt, swing alt. until its out. replacement is reverse of remova;
To take out the alternator on a 88' tercel, you have to do it from under the car
the voltage regulator is built into the alternator
The timing setting for a 1988 Toyota Tercel is the "3E" hole lines at the top. This setting is for a Tercel EZ 1500 engine.
Tercel EZ
How do you replace the alternator on a 1988 Pontiac Fiero
http://www.modifiedlife.com/1988-toyota-tercel-car-stereo-radio-wiring-diagram/ Change the year in the link to your Tercel's year
To replace the alternator on a 1988 Toyota pickup, first disconnect the negative battery cable to ensure safety. Remove the drive belt by loosening the tensioner, then unbolt the alternator from its mounting bracket. Disconnect the electrical connections from the alternator, and then install the new alternator by reversing the removal steps, ensuring all bolts and connections are secure before reconnecting the battery. Finally, adjust the drive belt tension as needed.
You can find a 1988 Toyota carburetor diagram at most Toyota dealerships. The diagram can also be found in Toyota service manuals at your local library.
2 hours max....
Hou much should it cost to replace an alternator for a 1988 acura integra Ls?
A quarter of a million miles if you treat her right
Disconnect the 1988 Century battery. Remove the alternator battery. Disconnect the alternator wiring, then unbolt the alternator. Bolt in the new alternator, then reverse the procedure to finish the installation.
To bleed the cooling system on a 1988 Toyota Tercel, start by ensuring the engine is cool and remove the radiator cap. Run the engine until it reaches operating temperature, allowing the thermostat to open, and keep the heater on high. As the engine runs, check for air bubbles in the radiator; if present, add coolant until it reaches the proper level. Once the bubbles stop and the coolant is steady, replace the radiator cap and check for leaks.