Best Answer

is it a convertible? if so the onlt thing that you do is lift the flap in the corners ( with the top up of course) and there you will find the speakers. Simply undo the screws and unhook the connection. Then you put the new speakers back in the holes, attach the wires and put the screws back in.

User Avatar

Wiki User

โˆ™ 2005-07-30 18:19:18
This answer is:
User Avatar
Study guides
See all Study Guides
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you replace the back speakers in a 1991 Chrysler LeBaron?
Write your answer...
Related questions

How do you replace the computer unit on a 1991 Chrysler lebaron?

Replacing the Electronic Sending Unit on a 1991 Chrysler LeBaron is something that needs to be done by a professional. It\'s not something that should be taken lightly as a misplaced unit can make the whole car run badly.

Does a 1991 Chrysler LeBaron have a modulator valve?


How do you replace the fuel pump on a 1991 Chrysler LeBaron Coupe?

its in your fule tank you have to drop your tank and remove your sending unit drive safe

Where is the emergency gas shut off in a 1991 Chrysler lebaron?

Chrysler does not use shut-off switches.

How many pulleys are on a 1991 Chrysler lebaron?

There are 7 acording to Haynes

What weight of oil do you use in a 1991 Chrysler LeBaron?

conventional 10w30

What is the amount of oil in a 1991 Chrysler LeBaron?

Engine, 4.5 quarts.

Where is the Fuel Relay switch on a 91 Chrysler Lebaron Sedan?

The 1991 Chrysler LeBaron fuel relay switch can be found in the engine compartment on the firewall. The fuel relay switch will be on the passenger side of the firewall.

How do you disengage the airbag on a 1991 Chrysler LeBaron?

It is illegal to disengage the Air Bag on this vehicle.

Were is the PCV valve on a 1991 Chrysler Lebaron?

You will find it (the PVC valve) in the same place as you would on a 1995 Lebaron 3.0. I own a 1990 Chrysler lebaron 3.0 v6 and found the PVC valve in the same spot. Look up where to find the PVC valve on a 1995 lebaron 3.0 on this site. Best of luck.

What is the gap on spark plugs for a 1991 Chrysler LeBaron?

If it is a 3.0 liter V6 EFI. Then it will be .044

What transmission is in a 1991 Chrysler LeBaron?

Three speed is called a 31th (A413) overdrive is called a 41te (A604)

Why is your 1991 Chrysler lebaron 604 trans in limp mode?

The transmission computer has detected a malfunction and set a code.

Can you mix 10w30 oil with 10w40 in a 1991 Chrysler LeBaron?

Yes, as long as the ambient temperature is above fifty degrees.

Where can you find a donut tire for a 1991 Chrysler LeBaron?

The tire is stored in the trunk. If you do not have one, check local salvage yards.

Is the fuel pump on a 1991 Chrysler lebaron in the fuel tank?


Where is the oil sending unit located on a 1992 Chrysler lebaron V6 convertible?

If it is the same as my 1991 Lebaron it is located just above the oil filter. You will have to take the oil filter off and the starter off to get to it.

1991 Chrysler LeBaron after a full tune up your car still shut off?

Fuel pump, distributor sensor, computer,

What size rear speakers is in Chrysler Le Baron Convertible 1991?

I BELIVE THERE 3 / 9 ''S No. There is rounded speakers but I don

Will a 3.3 Chrysler engine fit in your 1991 lebaron?

The Chrysler 3.3 engine should fit because the 3.3 was designed to replace the crappy 3.0 Mitsubishi that came with them. Do not forget to change the ECU and the transaxles, too. BTW, the 3,0 Litres newer than 1992 is not crappy, usually it is the owner who does not care about

Where is the voltage regulator located on a 1991 Chrysler lebaron 3.0L?

AnswerVoltage regulator is inside the engine computer.

Cant find the power steering in 1991 Chrysler lebaron?

its at the back of the engine.. located under the dipstic/ filler tube to the right of the alternator

Where is the power steering on a 1991 Chrysler Lebaron?

pump..?? behind the engine left side.. follow the filler tube donw you'll find it..

Are 1991 and 1995 Chrysler LeBaron parts interchangeable?

Most would beMost would be

Is it necessary to remove the fuel lines when changing the timing belt camshaft seals and crankshaft seal on a 1991 Chrysler Lebaron V6 3.0L?

Yes it is