Take the glove box out then behind it if you listen you can find the blower mtr not all the facts but its how far I got
Something called a blower control module takes the place and is found in the hole where you would find a blower resistor, so there isn't a blower resistor in that vehicle. As far as the blower control module is concerned, the module is serviced as a unit. No part can be fixed or replaced. This is not to be confused with the control head in the dash. The blower control module is held into the heater box with two 8mm screws outside the firewall under the hood, where you would normally find the blower resistor pack.
It may only be the resistor pack or the resistor module depending upon your climate control type.
On the auto temp unit it is called a blower power module.
the resistor is located in the blower module which is located under the hood by the a/c evaprator case
Bad electronic resistor / blower module - replace.
No. An AC/heater control module is a computer that controls and automates the operation of the heating, ventilation, and air conditioning systems (HVAC).The blower resistor enables the blower motor to change the speed of the fan.
Check the control module, the resistor, etc......
Blower resistor is behind the blower motor up against the firewall you can see wires hanging down from it. (Mite be called blower control module in 2005 models.)
You have to remove the wipers and the cover that's underneath them. There is a hole on the passenger side that allows access to the resistor from under the hood.
There is none - usually it is the module in the top of the heater / blower box (resistor module) that is the problem.
replace blower resistor
What model? This probably has electronic Climate control,therefore there isn't a Blower resistor. The blower is controlled by a Blower Motor Module...its mounted on the HVAC case under the hood near/next to the blower motor.