On the passenger side of the vehicle, under the dash is the blower moter, there are two wires running from it, the one running to the resistor is mounted on the firewall. you remove the two screws with a star shaped screw driver, unplug the old resistor and plug in the new one...takes about 15 minutes.
the heater blower resistor is located on the passenger side footwell near the firewall. a complete how-to replace the resistor, along with photos is available on newcougar.org http://www.newcougar.org/forums/how-tos/3732-fixing-heater-blower-resistor-install-photos.html
Sounds like a blower resistor. Instruction for how to replace this resistor can be found in the link below. Thanks to newcougar.org user Goldie for the How-To. http://tutorials.newcougar.org/HowTofixheaterblowerresistor.pdf
The Mercury Cougar blower motor is located on the firewall in the engine compartment. The blower motor can be seen on the passenger side of the firewall.
Take it to a repair shop.
How do you replace a fan blower resistor on a vauxal Corsa?
When the heater resistor goes, your climate control fans will only work on the fourth setting. You can get a new resistor from any Ford Lincoln Mercury dealer, though they may have to order one.
It is probably the resistor. I had the same problem with my 99 Cougar. It is located on the passenger side under dash. Check with Ford. I think that this part was recalled.
In the black box right beside the battery. There are 2, a high speed and low speed relay.
If the blower works on some speeds and not on others, you may not need a motor. Instead, you may only need a new blower motor resistor.
open your glovebox, release the hydraulic arm from the right side of the glovebox. Next, lower the glovebox by pulling in left side. In front of you is the blower motor. To the left of the blower motor is a set of wires that are plugged into the Resistor. Unplug and unscrew to remove Resistor.
The blower motor speed resistor is burned out. You can replace only the resistor but the resistor probably burned out because the blower motor is going bad. If you want to fix it for good, replace both the blower motor and blower motor speed resistor.
how to replace blower resister on a 325i BMW 2002
# Locate the blower resistor under the right-side of the instrument panel # Disconnect the electrical connector from the blower motor resistor # Remove the blower motor resistor mounting screws and remove the resistor from the housing # Installation is the reverse of removal
The blower is controlled by the blower switch, blower resistor, and relevant power relay.
Check to see if you are getting power to blower motor - if so replace blower motor If not check fuse, switch, resistor pack.
A bad heater blower motor resistor would effect one or more blower speeds other than high.
A blower resistor can be replaced, in your 2002 Oldsmobile, by removing the resistor wiring. Remove the retaining screws. Reverse the process to install the new resistor.
have you checked the fuse if so then you will need to replace the resistor for the blower hig and low dettings have you checked the fuse do you have 12 volts to blower if so then you will need to replace the resistor for the blower replace the blower motor
where is the switch resistor on 2003 buick
You must remove the glove compartment door to access the blower motor. On top of the blower motor will be wires connecting to the top. Release the connecter and let it dangle. Then using a screwdriver, remove the blower resistor on top, where the wires connected, and replace with a new resistor.
There is really no method to "check" the resistor, text by substitution.
Blown fuse, defective blower motor resistor pack, defective blower motor, or loose or disconnected wiring.
To replace a blower motor on the resistor first you take off the nozzle and then you go into the motor through the nozzle and unlock it then repeat and oil and done.
One can replace blower motor resistor on 2003 Nissan altima by removing the old using spanners and replacing it with a new one.
To change the blower motor resistor in a 2002 Nissan Maxima, locate the blower motor resistor under the glove compartment on the passenger side of the vehicle. There is a clip that is depressed and then the resistor will slide out. Remove both ends of the resistor and then replace with the new resistor.