BODY CONTROL MODULE
REMOVAL
Disconnect battery negative cable.
Remove lower steering column cover and knee blocker reinforcement.
Disconnect two wire connectors from bottom of Body Control Module (BCM) Body Control Module .
Remove bolts holding junction block to dash panel mounting bracket.
Remove junction block from mounting bracket.
Remove screws holding BCM to junction block.
Slide BCM downward to disengage guide studs on junction block from channels on BCM mounting bracket.
Remove BCM from junction block.
INSTALLATION
Reverse the preceding operation The BCM is located near the parking brake behind the drivers side kick plates (mentioned above) It has 5 plugs in it, one 6 pin plug and four 34 pin plugs.
yes
yes
Take your car to a Chevy Dealer
How do I test body control module and is it hard to do..
how do you replace a wiper control module in dodge 1998
It doesn't have a body control module.
How do I test body control module and is it hard to do..
just unplug it but do not have the car on. Also you will have to get it programed.
just make a long story short replace the BCM or BOdy Control Module just as easy as pie. ;-)
The body control module can have everything to do with it. If the engine computer and the body control module do not have communication between one another than the engine will start then die after 2 sec.
It is called a throttle body control module. It is in the engine compartment on the top of the engine.
The body control module is located behind the glove box.