Master cylinder or drum brake (hydraulic slave) wheel cylinder or disc brake caliper cylinder?
drum brake shoes rear
To replace the brake light bulb on a 1996 Ford Ranger is very simple. There are four bolts that hold the housing that will need to be removed. After the bolts are removed, the wires connector needs taken off and then the bulb can be twisted out.
remove the two nuts holding the master cylinder on the power brake booster
Firing order for 1996 Ranger 4-cylinder engine is 1-3-4-2.
1996 ranger does not have speedo cable it is electronic
The front engine cylinder
follow the top radiator hose to the engine, remove it then remove the thermostat housing, remove the thermostat and replace it
In a 1996 Ford Ranger : The factory available engines were : 2.3 liter four cylinder ( 4 cylinder ) 3.0 and 4.0 liter V6 engines which are ( 6 cylinders )
in the brake master cylinder
For a 1996 Ford Ranger : Regular cab , short box ( 16.5 U.S. gallons )
( Yes ) the 2.3 liter four cylinder engine in a 1996 Ford Ranger is fuel injected
Above the brake pedal where the master cylinder is attached to the brake pedal assembly.
Brake lines come out of the master cylinder and go to each wheel.