How do I get to the bottom bolt on the coil pack of my 2000 Camry
The 2000 Saturn does not have a distributor. Instead it uses a "coil pack" system.
remove the plastic engine cover from top of engine, you will have to pull the fuel rail as it runs above the coil packs, remove the screw that holds the coil pack and unplug the harness then pull coil pack and plug wire assembly out.
were about on the engine is the coil pack for a renuault 1.4 16 vaule
Your coil-packs are what deliver spark to your spark plug. This way there is no need for the old distributor style stuff. Plus it's a lot easier to replace a coil-pack than it is to replace a distributor
bad coil pack... replace coil pack
To replace a coil pack you will have to do a few steps. Start with disconnecting the battery cable, open hood, go to the coil pack, unplug the old one, plug in the new one, recharge the coil pack and then shut the hood.
There is no "coil pack", but actually there are eight individual coils. You can determine the mis-firing coil by accessing the on-board computer and replace the defective coil,or just replace the boot and see if this cures the problem. The replacement boot is about $5 and the replacement coil is $50, more or less at your local parts house. Good luck!!
The coil pack on a 2000 Pontiac Sunfire is located behind the air intake hose. Just behind where the air intake hose connects to the top of the motor is where the coil pack is on this vehicle.
disconnect wires and label them,each coil has its own screws holding it to plate,take out scews,pull coil straight up do not bend the coil tangs at mounting of coil. Do this for each coil! HOPE THIS HELPS!
A coil pack can be checked for continuity and resistance with an ohm meter. But for heat or load failure the only way to check a coil pack is to replace it.
How do I install a coil pack for Hyundai sonota 2000
There is no coil pack on that year.