Ford Escape XLT
Ford F-150
Ford Ranger XLT
1982-1994 Chevy Cavaliers

How do you replace the coil pack on 1994 cavalier?

262728

Top Answer
User Avatar
Wiki User
2007-05-18 17:39:48
2007-05-18 17:39:48

follow your spark plug wires under the motor to the ignition module where the coils are mounted and the wires are attached to them. use a wrench and a screw driver to take off the module and the coils. do not lose the plug firing order.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

How do you change a coil pack on a 1997 cavalier

User Avatar

The coil pack, on a 1996 Chevrolet Cavalier, is located on the top of the engine. The coil pack is near the electronic spark distributor.

User Avatar

were about on the engine is the coil pack for a renuault 1.4 16 vaule

User Avatar

How do I get to the bottom bolt on the coil pack of my 2000 Camry

User Avatar

at the bottom of the block, under the coil pack

User Avatar

coil----3 - 4 pack---2 - 6 plug----1 - 5 for the coil pack towers ( 3.0 and 4.0 liter V6 engines ) on a 1994 Ford Ranger

User Avatar

coil----3---4 pack---2---6 plug----1---5

User Avatar

Trace the spark plug wires they start at the coil and end at the spark plug

User Avatar

A coil pack can be checked for continuity and resistance with an ohm meter. But for heat or load failure the only way to check a coil pack is to replace it.

User Avatar

well the 90 3.1 is the same as the 2.8 where the coil pack module is located underneath the front exhaust manifold to replace the module u have to take out all 3 coils leave the park plug wires connected and then disconnect the wires to the module and take out a couple of bolts and just replace it the way it was

User Avatar

There is no coil pack on that year.

User Avatar

how do you put spark wires in the right place on the coil pack on a 1995 Chevy cavalier2.2 frank

User Avatar

The Avenger did not exist as a 1994 model.

User Avatar

no distributor or spark plug wires its a coil pack on the top of the engine.

User Avatar

Click the link and then choose the correct engine size.

User Avatar

http://www.ehow.com/how_4509339_replace-ignition-coil-pack-ford.html

User Avatar

About 200$ for parts and labor

User Avatar

coil----------3------4 pack---------2------6 plug----------1------5

User Avatar

The car will idle rough and hesitate during acceleration.

User Avatar

THE FIRING ORDER FOR A 2.8 V6 88 CAVALIER IS 1,2,3,4,5,6, THE COIL PACKS ARE 1-4 6-3 2-5

User Avatar

after the year 1994, Mitsubishi started using a 'coil pack' instead of a distributor system.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.