disconnect the neg battery terminal.the crank sensor is on the drivers side in the back of the engine where the engine and the transmission meet.there will be a little cover with two 10mm bolts holding it in.it is a very very tight spot you can see or get the bottom bolt from underneath if you can get the vehicle up.Please use extreme safety precautions if using a jack.once you get those two bolts out remove the sensor the connecter for the wire should be near number 6 fuel injector
yeah it has one and hope you don't have to replace it
The crankshaft sensor on a 4.0L Jeep Grand Cherokee is mounted on the top driver side of the transmission bell housing.
YesYes
You can not. The crankshaft position sensor is required to run the engine.
Yes.
check the crankshaft sensor
The crankshaft position sensor is on the top driver side of the transmission bell housing.
Crankshaft position sensor mounting bolt.
Top driver side of the bell housing.
It goes into the top of bell housing.
The crankshaft position sensor is on the top of the transmission bell housing behind the passenger side cylinder head.
the crankshaft sensor is behind the cylinder head on the top of the bell-housing (where the motor and transmission bolt together)