answersLogoWhite

0

lower window

To Remove door panel

pry off cover on handle, two screws beneath. pull out on door lever, release linkage, unplug door lock connector. Reomove two screws under armrest. release plastic button clip near mirror (pop center bit out carefully with pin or pick). Pop off mirror cover. You can either leave switch assembly in door and carefully unplug wires once it's off. To remove it, you release it via flat scredriver up thru pry hole in armrest below aft edge of switch panel. (little square hole that you see if you look straight up)

Carefully pry/pull panel off, unplug connectors for rear glass switch window/mirror switches, release two tiedowns that tether wiring harness to door. (whew)

Next, pop off retaining plug and carefully peel back plastic door liner.

Using impact driver or very strong/big bit screwdriver with much pressure, remove three screws that hold door latch to door. (you will strip the heads of these screws unless you apply very strong pressure towards door hinge and use the proper size Phillips bit....they are very tight). Leave one screw in loosely until you are ready to extract it.

Unplug door lock actuator connectors, pop off door lever attachment and linkage guide for internal lever. (helps to have "U shaped' ulpholstery pry tool for the bigger linkage.)

Mark position of bolt and Unbolt rear window guide. You can pull this partway out of the rubber bit and let it sit in the door.

Remove the door latch assembly (kinda like that creature in the movie 'alien').

The actuator pops on and it held with a screw. Be sure that the little cam is engaged properly.

When you are all done, reset the auto up/down feature by closing the window fully and hold button for 2sec. Ditto for down.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you replace the blend door actuator on a 2003 Honda Civic Hybrid?

Disconnect the battery supply. Remove the inside driver side dashboard under cover. Remove the actuator and screws. Reverse to install.............


How do you fix 2003 Mercedez C230 Drivers Door lock actuator?

To fix the door lock actuator on a 2003 Mercedes C230, first, remove the door panel carefully to access the actuator. Disconnect the wiring harness and remove the screws holding the actuator in place. Replace it with a new actuator, reassemble the door panel, and test the lock to ensure it functions properly. If you encounter any issues, check the wiring and connections for any damage.


How do you find and replace a climate control actuator on a 2003 envoy?

To find and replace the climate control actuator on a 2003 GMC Envoy, first, locate the actuator, which is usually situated behind the dashboard near the heater core. Remove the necessary panels and screws to access the actuator. Disconnect the electrical connector and unbolt the actuator from its mount. Replace it with a new actuator, reassemble the components, and ensure everything is securely fastened before testing the climate control system.


How do open the drivers door with actuator problems on a 2003 KIA Optima the door is locked and will not open?

please answer


How do you replace rear blend door actuator 2003 aviator?

To replace the rear blend door actuator in a 2003 Lincoln Aviator, start by disconnecting the vehicle's battery and removing the rear passenger side trim panel to access the actuator. Unplug the electrical connector from the actuator and remove the mounting screws. Replace the old actuator with the new one, secure it with the screws, and reconnect the electrical connector. Finally, reassemble the trim panel and reconnect the battery.


How do you replace the headlight in a 2003 Oldsmobile Silhouette?

how do i replace the drivers side headlight in a 2003 oldsmobile silhoutte


How do you replace air actuator on Denali 2003?

To replace the air actuator on a 2003 Denali, first, disconnect the vehicle's battery to ensure safety. Remove the necessary interior panels to access the actuator, which is typically located behind the dashboard. Disconnect the actuator's wiring harness and unscrew it from its mounting. Install the new actuator by reversing the process, ensuring it’s securely fastened and the wiring is properly connected before reassembling the panels and reconnecting the battery.


How do you replace the left quarter glass in 2003 Honda Civic?

cmon


How do you replace a shift lock actuator on 2003 Lincoln Navigator?

To replace the shift lock actuator on a 2003 Lincoln Navigator, first, disconnect the negative battery cable to prevent electrical issues. Remove the center console by unscrewing any fasteners and gently lifting it out to access the actuator. Disconnect the wiring harness from the old actuator, remove it from its mounting, and then install the new actuator in reverse order. Reassemble the console, reconnect the battery, and test the new actuator to ensure proper functionality.


How do you replace a 2003 volkswagen drivers door mirror?

What model?


Why does electric door lock on drivers door 2003 Jeep Liberty make a loud screeching noise when lockingor unlocking doors Sometimes the electric drivers door lock does not work the key always works?

The lock actuator is going bad. The actuator is part of the latch.


How do you find and replace an actuator for a 1999-2003 ford windstar lx climate control switch?

electric window binds on 2003 ford windstar