I have the same problem. Drivers side master window switch is broken. I continue to use mine, but it doesn't always work. I think the answer is to buy a new switch. They are $300 + Canadian from the dealer....less from a scrap yard. The actual replacement is easy, carefully pry up the complete houing from the door ledge, disconect the wire hardness. Reverse to put the new one in place. I pulled mine out, the switch itself levers on a tiny thing piece of plastic, it's only a matter of time till they go. Best of luck.
I have repaired two of these by simply spraying contact cleaner on the slide switch under the driver window toggle switch. Use a small, flat bladed screwdriver to gently lift the plastic tab catches while prying the cover sideways. There is two sets of catches. Do the black one first then the gray. The window lock pushbutton will need to be pryed off as well. Be sure to realign all the toggle switches upon reassembly.
It is not possible to replace single switch in the driver side window cluster of Ê2000 Chevy Tracker. The cluster is only sold as one piece and single switches cannot be purchased.
you have to replace the central switch cluster in whole. cant be repaired individually.
Do you mean the main switch by the driver or the switch on the door itself?
The driver side electric window switch on a 1992 Acura Integra is reached by removing the door panel. Unbolt the switch from the mounting bracket and disconnect the wiring from the harness. Replace the unit.
The switch is burned out. Replace it.
I would try the window switch first , but if you are going to replace the switch then you will see how to replace the motor. You would have to take the door panel apart after that its easy.
well iam a retard you have take off the door panel to get to the motor but to replace the window switch get a flathead sd and stick it under the front of the switch holder and lift up
you should be able to take the cover off the driver's door by unscrewing it,then unplug the window switch and replace it,fairly easy..
From my 07 manual:Start the engine. Push down and hold the driver's window switch until the window is fully open.Pull and hold the driver's window switch to close the window completely, then hold the switch for about 2 seconds.
Pop the door panel off. Remove screws including the one behind the window switch. Then, lift up on the panel. You will see where the window switch plugs in.
had same problem; check switch on driver side ., if it operates the passenger side ok, then just replace the driver side window switch .. $20 part from the dealer.
how to replace window toggle switch 1999 buick century