its as easy as poppin the hood turn then bulbs about a half turn till they pop out then i think there is one screw on top holding the whole turn signal in. just slide it down a little and out, it may need some prodding, mine did. getting it back in you have to make sure to line up two grooves that slide together or it wont line up, or you could break something.
a Phillips head screw driver
Take out your owners manual. Its the one hiding in your glove box =) Most likely its just a fuse, which are really inexpensive!
Unscrew the screw that attaches it to the headlight. Pop it out. Twist bulb so it comes out.
may have bad bulb
No
Open the hood. Near the front of the turn signal assembly there is a Phillips head screw. Loosen but do not remove the screw; it releases the front of the assembly. You then need to pull forward to release the pin holding the rear of the assembly. Reverse the above to replace the assembly.
it is in taylorville
yes, try a junk yard before going to a Toyota dealer
Rear end of what?
Reach behind the bumper of the 99 Cavalier. There are two nuts that hold the turn signal assembly in. Remove the nuts to take the assembly off and replace it.
The turn signal flasher is a three prong plug in on a Toyota Rav4. It is located under the dash on the driver's side of most Toyota vehicles. Take the old plug out and insert the new one.
no.