Headlights Tail and Brake Lights
Pontiac Sunfire
Ford F-150

How do you replace the headlight bulb located on a 1999 Pontiac Sunfire?

343536

Top Answer
User Avatar
Wiki User
2006-02-15 01:35:45
2006-02-15 01:35:45

remove the black plastic radiator cover (push-pins) then remove the two bolts holding the headlamp in unplugh the bulb harness and remove. unscrew the plastsic ring around the bulb, and reverse to install. Open the hood. The first thing to remove is the thin, black, plastic shield that runs from one headlight to the other. There are small, round, black, plastic fasteners holding this piece down. Use the blade of a scredriver to pull up the centermost portion of the fastener. Be careful not to break this tab off. Once you raise it up enough, you can grasp it and pull them out. Next remove the two bolts that anchor the headlight assembly. Pull the assembly to the front of the car to access the bulb assembly behind it. Slightly twist the bulb retainer counter-clockwise and pull the bulb assembly out. Life the plastic locking tab and disconnect the bulb. Snap a new bulb into place. Reinstall the bulb assembly by following the directions in reverse.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

when should the vapor canister be replace on a 1996 pontiac sunfire

User Avatar

There is no speedo cable on a Sunfire.

User Avatar

what you do is you open the hood and right above the headlight is a black plastic cover held on by little plastic clips. take that off and you'll see two bid bolts connected to the frame of the headlight. take them off, jiggle the headlight alittle, and it should come right out

User Avatar

how do you repair an inner tie rod for a 96 Pontiac sunfire no repair,replace with new.

User Avatar

There are bolts surrounding the headlamp. remove these and the wires.

User Avatar

You can replace a timing chain on a 2002 Pontiac Sunfire by visiting a local mechanic and having him take care of it for you. This is a tricky part to change yourself.

User Avatar

two bolts on the top of the plastic housing - lift the plastic headlight out and unscrew the headlight from the bottom of the light- replace the bulb and be sure to get the plastic pins in the right spot before you bolt the headlight back in place.

User Avatar

There is 2 large plastic screws that hold the headlight assembly`s in. Simply unscrew them and lift the headlight assemblies out then unhook take the bulbs out.

User Avatar

The labor to replace a clutch on a 1996 Pontiac Sunfire can range from $670 to $850, depending on where you go. This does not include the cost of the clutch itself, which is roughly $800.

User Avatar

OK ... Here's the REAL answer: You cannot change the bearings on a Pontiac Sunfire. You must replace the "Hub-Assembly" they will be the same on both sides .

User Avatar

Remove the panel under steering wheel. There will be 2 flashers. Replace one on right.

User Avatar

How is the ignition key switch replaced on the 2000 Pontiac Sunfire? And after replacing the switch would I have to have it Towed to the Pontiac Dealer in order to have the car key programed to the Computer?

User Avatar

Look under the vehicle - follow the fuel line from the tankRemove clamps and support to replace

User Avatar

take the wheel well out first then reach in and turn bulb socket

User Avatar

I've never had to change mine, but it's an in-line filter located near the gas tank.

User Avatar

What it will cost you to replace the distributor cap on a Pontiac Sunfire will vary depending on if you do it yourself or if you take it to a garage. The cost can be over $100 if you take your car to a garage.

User Avatar

how do you replace headlight bulb in a 2001 celica gts

User Avatar

No, not just because you ran out of gas but you should replace the fuel filter.

User Avatar

The bulb itself is removed by unscrewing it from behind the lense under the hood.I hope this helps you. Mark

User Avatar

Pull off panel under steering wheel. You will see two separate flashers. Replace the one on the right.

User Avatar

tug the hose Drop the fuel tank, disconnect lines, remove pump and unit, reverse procedure to install.

User Avatar

Pick up a Haynes or Chilton manual for your car. Follow their directions.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.