answersLogoWhite
Grand Prix GTP

How do you replace the headlights on a 1998 Pontiac Grand Prix GTP?

686970

Top Answer
User Avatar
Wiki User
2015-07-15 20:49:25
2015-07-15 20:49:25

With the hood open remove the (2) two headlamp assembly bolts from the upper fascia support.

Slide the headlamp assembly outward enough to release the headlamp bracket tabs from the slots in the upper fascia support.

Position the headlamp assembly away from the vehicle body to access the electrical connector.

Disconnect the electrical connector from the headlamp assembly.

Remove the headlamp assembly from the vehicle.

If you wish to change the halogen bulb:

Disconnect the electrical connector from the headlamp bulb/socket.

Remove the headlamp bulb/socket retainer ring from the headlamp, by turning counterclockwise.

Remove the headlamp bulb/socket from the headlamp assembly.

.

G

These instructions are similar from around '96 to '03 grand prix model years all trim levels.

1

Related Questions

User Avatar

yes, they are always on. as in most gm vehicles they have daytime running lights.

User Avatar

Where is the starter on a 1998 Pontiac Grand Am, 6 cylinder

User Avatar

drive cycle for 1998 pontiac grand prix, 3.8 engine, no super charge?

User Avatar

Are you talking about the oil pan reservoir at the bottom of your motor?

User Avatar

on a 1998 Pontiac gan am ,they do not have a pcv valve.

User Avatar

thanks to our friends at www.AUTOZONE.com go to the link on the right of the page

User Avatar

You will need to remove the tire and wheel from your 1998 Pontiac Grand Am. Remove the brake assembly spring from the brake pads. The brake pads will come off. Reverse the process to install the new brake pads.

User Avatar

How to replace 1998 Toyota corolla headlights

User Avatar

I have a 1998 Pontiac Grand AM GT that coolant sensor went bad. So how do you change it with out breaking the coolant

User Avatar

how do you change a brake booster valve to a 1998 Pontiac transport

User Avatar

Take it to the dealer, You don't have the proper tools to do this correctly. lol seriously? its a torx head screwdriver.. that's all that's necessary

User Avatar

You can easily get all of the color codes for every wire on the 1998 Pontiac Grand Prix. Pontiac has an official website homepage that has all the information on it.

User Avatar

where is the location of the body control module on a 1998 grand am se

User Avatar

How do you replace passenger side fender on a 1998 pontiac bonneville se

User Avatar

Under the hood right by the light housing there should be a knob that you can turn manually to open the headlights

User Avatar

The torque of the 1998 Pontiac Grand Prix is 220 ft.-lbs. at 4000 rpm. This remained the standard for all sixth generation models of this car.

User Avatar

All 1985-1998 Pontiac Grand Ams take 19" replacement windshield wiper blades on both sides front.

User Avatar

This website has one. http://www.devicemanuals.com/guide/Automobile/Pontiac/Pontiac-Grand-Prix-Owner%27s-Manual-1998-==TVRFd01qSXc=.html

User Avatar

The warning lights on a 1998 Pontiac Grand Am mean that the vehicle's computer has detected a problem. This can range from low tire pressure to malfunctions within the engine itself.

User Avatar

The camshaft position sensor on a 1998 Pontiac Grand Prix is located behind the rear bearing of the camshaft. It constantly monitors the rotation of the camshaft and relays this information to the computer.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.