Lift front hood Remove cardboard covering over the dash panel area. Locate the lamp holders and replace lamps as required. Reassemble.
How I have to do for replace a little bulb on the ODO speedometer cable on 1973 Super Beetle ?
Its not as hard as it sounds, but you have to take off the door panel first. Then you loosen the bolts for the window regulator. Then its just working the winow and out. On my 73 super beetle, I fond it easier to remove the small vent window also.
In a 1971 Super Beetle, the dimmer switch for the dashboard lights is typically located on the left side of the dashboard, just to the left of the steering column. It may be a small knob or a toggle switch that allows you to adjust the brightness of the instrument panel lights. If you're having trouble locating it, check for any markings or symbols that indicate its function.
Replace the flasher relay if the lights come on but do not flash.
The 1975 regular Beetle windshield will fit the 1971 Super Beetle.
If you look at the front suspension of any beetle you can tell if it is a super or non-super beetle. If there is a McPherson front suspension then it is a super beetle. If there is a torsion bar front suspension then it is a non-super beetle.
The super beetle was not put into production until 1971, there is no such vehicle as a 1964 super beetle.
It should be in the fuse panel in the luggage area near the fire wall.
To remove the dashboard on a 1974 Super Beetle, first disconnect the battery to ensure safety. Remove any screws or bolts securing the dashboard, typically found around the edges and under the instrument panel. Carefully detach any wiring connected to the dashboard components, such as the speedometer and switches. Once everything is disconnected, gently pull the dashboard away from the mounting points to complete the removal.
“looking to see if the 72 VW I own is a Beetle or Super Beetle? VIN # 1122369336”
Figure $350 for a rebuilt unit, $100-150 to install.
The rear windows on a 1979 Super Beetle convertible are replaced by prying away the rubber molding holding the glass in place. The glass can then be slowly lifted away before new sealant and glass is installed.