Go to this site: > http://www.focushacks.com/index.php?modid=88 <
you take apart the dash and get to the instrument panel. then you take the instrument panel out and on the back of the panel you'll will see the lights
How to replace intrument panel lights on 2002 cadillac escalade
with a hammer
instrument panel or controls?
To replace the lights on the instrument panel of a Land Rover Discovery TD5, first, disconnect the vehicle's battery to ensure safety. Remove the instrument panel by unscrewing the securing screws and gently pulling it out. Locate the bulb holders on the back of the panel, twist them counterclockwise to release, and replace the burnt-out bulbs. Reassemble the panel and reconnect the battery to test the new lights.
To replace the instrument panel lights on a 1993 Toyota Camry, start by removing the dashboard cover and the screws holding the instrument panel in place. Carefully detach the panel from the dashboard, then locate the bulb sockets on the back of the panel. Twist the sockets counterclockwise to remove them, replace the old bulbs with new ones, and reassemble the panel by reversing the disassembly steps. Ensure all connections are secure before testing the lights.
To replace the instrument panel lights in a 2000 Volvo S70, first, disconnect the car battery to ensure safety. Remove the trim surrounding the instrument panel by carefully prying it off. Unscrew the panel screws, then pull the instrument cluster out. Finally, twist the bulb sockets counterclockwise to remove the old bulbs and replace them with new ones before reassembling the panel.
Not sure if the 2003 is the same, but on my 2001 I needed to replace Fuse 32, which is located in the fuse panel under the instrument panel on the driver's side
you cannot service panel lights on 2000 impala . you hav to replace the instrument cluster.
Check fuses-- common circuit
To replace the instrument panel lights in a 1994 Buick Regal, first ensure the vehicle is off and disconnect the negative battery cable for safety. Remove the instrument panel by unscrewing the screws that secure it, then carefully pull it out to access the bulb sockets. Twist the bulb sockets counterclockwise to remove them, replace the old bulbs with new ones, reassemble the panel, and reconnect the battery cable. Finally, test the lights to ensure they are functioning properly.
All the lights a flashing on the instrument panel on my Chrysler town and country minivan. Why?