Well, first take only the necessary dash parts off... which would be practically the whole thing. Look carefully for screws because if you force it, there's a good chance you'll break the dash itself, which is no fun. Once you get that off, there are four screws to unscrew the radio... Do so. Then pull the radio out carefully and depending on the radio you're replacing it with, either cut the wires or just use the port and plug it into the new radio. If you cut the wires, be sure to either label what controlled what, or find yourself a handy wireing diagram. If you do that, make sure you get a meter and test each wire to see which one is hot. Tape that wire up right away with the correct wire for your radio, and then start trying to connect the speakers. Btw, there are most likely two hot wires. One that stays hot ALL the time, and one that is only hot when your ignition is started.
Hi, How Do You Replace a Starter on a 1995 Isuzu Rodeo, V6, 3.2 liter engine? Does anyone know where the starter is? Help. How Do You Replace a Starter on a 1995 Isuzu Rodeo, automatic, 4wd, V6, 3.2 liter engine? Does anyone know where the starter is? Thanks alot.
replace stop light switch
where is the pcv valve located on a 1995 Isuzu rodeo v6 3.2l
How do you adjust the valves on a 1995 isuzu Rodeo 3.2
Hello... what is the original size of the muffler that came with a 1995 Isuzu Rodeo lengh etc...
Remove beltUnbolt tensioner and remove
On the left
Take old spark plugs out put new spark plugs in
it takes 3.2L
it will fit but you will have to get new hoses for the correct sizes
The diagnostic port on a 1995 Isuzu Rodeo drive is located on the lower kick panel on the driver's side. It is just below the left spark plug.
The old broken one must be driven out and the new one driven or pressed in.
Near fuse box
its on the drivers side kick panel
have your intake gaskets checked common with rodeo
I saw on another web-site that stated the blue was (-) and the yellow was (+). This was for the front doors. Not sure about the rear. Hope this helps.
While the radio is on, hold the display button and then tap Tune Down for hour movement and Tune Up for minute movement.
Remove caliper and pull rotor off the hub. Push new one on, replace caliper and pads.
in the fuse panel.drivers side of dash.
No it is not, in 1996 Isuzu bumped the horsepower of their 3.2L V6 up to around 195 hp and 193 ft·lbf of torque for the 1996 and 1997 Rodeos continuing into 2004 in which Isuzu operated here in the states under GM dropped the Rodeo line
The 1995 Isuzu Rodeo has a curb weight of 4,110 pounds. The vehicle gets 15 miles per gallon in the city and 18 miles per gallon on the highway.
The 1995 Isuzu Rodeo will have one dipstick ?æon top of the engine, this is the oil dipstick. ?æThe transmission fluid is adjusted from beneath the car.
If its the bulb you have to unscrew the light cover and pull out the old bulb and put the new one in.Then screw the cover back on.