If you are talking about the High Brake Light at the top of the tailgate; 1 Take out the two Phillips head screws in the lens. 2 Carefully pry the lens straight back . The gasket sticks to the paint. You may want to try a thin piece of plastic between the paint and the gasket. But be careful not to rip the foam gasket. 3 The bulb is a 921
How can you manually release the emergency brake on the 1998 Toyota Sienna?
You will need to bleed the brakes, starting from the caliper furthese from the master cylinder then moving closer.
The Toyota Sienna should have high and low marks on the side of the brake fluid reservoir. Check to see that the fluid level is between the two marks.
Lift the car, remove the tire, remove the brake shoe/caliper and remove the old brake pad. Next, put in the new brake pad, replace the brake shoe/caliper, replace the tire and lower the car.
i just had the northridge Toyota resurface the rotors and changed the brake pads of my 05 sienna for 199+ tax... they are having some kind of brake special going on.
Um... Aren't all brake lights in the back of a car?
Manual says DOT 3
how to replace brake fluid on a 1999 Toyota 4runner
Lift the vehicle, remove the tire and set it aside, remove the brake shoe/caliper, and remove the old brake pad. Throw away the old pad, put in a new brake pad, replace the brake shoe/caliper, replace the tire, tighten the nuts, and lower the vehicle.
check the fuse that's if the bulb is not burnt out.
I need timing mark for Toyota paseo
To replace your brake light, you need to unscrew the brake cover from the inside of the trunk. Then you will be able to pull the old bulb out and replace it.
check your local mechanic
It is located in the back right section under a black cover.
anti-theft system in 2004 toyota sienna keep going of
It should only take about an hour to replace the brake lines on a 1995 Toyota Corolla. The exact time will depend on your experience with replacing brake lines.
According to my 2000 Sienna manual, an exclamation point in a circle with 2 parens on either side is a brake system warning light. Might want to get your brake system looked at.
Check brake fluid level in master cylinder Check to make sure parking brake is fully released
I have a 2000 sienna..........and had that light come on......in has to do with the braking system
I don't have 2000 specs, but according to the 2004 Sienna Repair Manual the torque spec for the front brake caliper mounting bolts is 79 ft-lbs and the torque spec for the brake pad pins is 25 ft-lbs.
Usually you have to pull the brake assy off then the brake disk and the small cap in the center of the axle. There will be a large nut under it that needs to be removed. This will give you access to the wheel bearings in front. ed724
How do you replace the front break pads on a Toyota corolla .
only toyota could be this stupid and incompetent...